Using The Projector; Powering On / Off The Projector - Optoma ZH520 User Manual

USING THE PROJECTOR

Powering on / off the projector

Powering on
1. Securely connect the power lead and signal/source cable. When connected, the Power LED will turn
red.
2. Turn on the projector by pressing the
control.
3. A start up screen will display in approximately 10 seconds and the Power LED will be flashing green or
blue.
Note:
The first time the projector is turned on, you will be prompted to select the preferred language, projection
orientation, and other settings.
Powering off
1. Turn off the projector by pressing the
control.
2. The following message will be displayed:
3. Press the
When you press the
4. The cooling fans will continue to operate for about 10 seconds for the cooling cycle and the Power
LED will flash green or blue. When the Power LED turns solid red, this indicates the projector has
entered standby mode. If you wish to turn the projector back on, you must wait until the cooling cycle
has finished and the projector has entered standby mode. When the projector is in standby mode,
simply press the /
5. Disconnect the power lead from the electrical outlet and the projector.
Note:
It is not recommended that the projector is turned on immediately, right after a power off procedure.
/ button again to confirm, otherwise the message will disappear after 15 seconds.
/ button for the second time, the projector will shut down.
button again to turn on the projector.
or
button on the projector keypad or the
button on the projector keypad or the
Power Off
Press power key again.
button on the remote
button on the remote
English
21