Brew Volumes And Measurements; Approximate Brew Volumes; Measuring Your Coffee Grounds; Intelligent Warming Plate - Ninja CFN600C Series Owner's Manual

USING THE NINJA® ESPRESSO &
COFFEE BARISTA SYSTEM – CONT.
6 To start, press START BREW. The brewer
will beep to signal the brew has started. The
progress bar around the dial will illuminate to
indicate the status of the brew. When finished,
the brewer will beep again, and End will
appear on the display.
NOTE: The brew cycle will begin, then pause
for a short period before resuming. This
process is used to evenly saturate the coffee
grounds. This applies to all brew styles.
7 To cancel the brew at any time, press
START BREW again or press the Power Button.

BREW VOLUMES AND MEASUREMENTS

Each size and brew style produces a different
amount of coffee to optimize strength and flavor.
NOTE: The coffee grounds will absorb some
of the water that is brewed; this will cause
slight variability in brew volumes than what
is stated below.

APPROXIMATE BREW VOLUMES

GROUNDS
Over Ice
Size Classic Rich (filled
with ice)
237 mL 207 mL 237 mL
Sm Cup
(8 oz) (7 oz) (8 oz)
296 mL 237 mL 296 mL
Cup
(10 oz) (8 oz) (10 oz)
355 mL 296 mL 355 mL
XL Cup
(12 oz) (10 oz) (12 oz)
444 mL 355 mL 444 mL
Travel
(15 oz) (12 oz) (15 oz)
532 mL 743 mL 532 mL
XL Travel
(18 oz) (16 oz). (18 oz)
828 mL 796 mL 828 mL
1 / Carafe
4
(28 oz) (26 oz) (28 oz)
1.1 L 976 mL 1.1 L
1 / Carafe
2
(37 oz) (33 oz) (37 oz)
1.4 L 1.2 L 1.4 L
3 / Carafe
4
(46 oz) (41 oz) (46 oz)
Full 1.6 L 1.4 L 1.6 L
Carafe
(55 oz) (46 oz) (55 oz)
NOTE: There may be some water left in the
reservoir after your brew. This is normal to
keep the brewer from running out of water.
10
1-855-520-7816
CAPSULES
Ristretto Espresso Lungo Over Ice
25 mL 40 mL 110 mL 30 mL

MEASURING YOUR COFFEE GROUNDS

For best results, use the measurements on the
Ninja Smart Scoop™ or in the chart to determine
how much ground coffee to use for each brew
size. Always use level scoops when measuring
ground coffee. The amount of ground coffee
for each size will remain the same for any brew
type you select. For example, if you select Cup
and Classic, you will use the same amount of
coffee grounds as if you were to select Cup and
Over Ice.
NOTE: Adjust to your preferred taste. More
scoops result in stronger coffee but slightly
lower volumes, fewer scoops result in weaker
coffee and slightly higher volumes. Use
fewer scoops of decaffeinated coffee to
prevent overflow. Use a medium-sized grind
if grinding whole beans. Grinding beans too
finely may cause the brew basket to overflow.
COFFEE MEASUREMENT CHART
Ninja Smart
Serving Size Tablespoons
Scoop
Sm Cup
2–3 2–3
Cup
small scoops tablespoons
XL Cup
Travel
3–5 3–5
small scoops tablespoons
XL Travel
/ Carafe
1
4
3–5 6–10
big scoops tablespoons
1 / Carafe
2
3 / Carafe
4
4–7 8–14
Full big scoops tablespoons
Carafe

INTELLIGENT WARMING PLATE

The Intelligent Warming Plate will automatically
turn on during Classic or Rich brews when any
carafe size is selected. The Intelligent Warming
Plate is set to a specific temperature setpoint to
avoid burning the coffee over time. To turn the
warming plate on at any time, press the Grounds
Button to select either Classic or Rich, turn the
dial to one of the carafe sizes, and press the
WARM button.
IMPORTANT: The
light on the base
of the brewer will illuminate only when
the warming plate is hot and will remain
illuminated until the plate has cooled down.
TIME & TEMPERATURE ADJUSTMENT
You can adjust how long the Intelligent Warming
Plate remains on (up to 4 hours) and/or set the
temperature to Low, Medium, or High.
By default, the Intelligent Warming Plate is set
to remain on for 2 hours and is set to medium.
To change the time/temperature settings of the
warming plate, follow these instructions:
1 Press and hold WARM until the clock begins to
flash the current warming time.
2 Turn the dial to increase the time in 15-minute
increments up to 4 hours or decrease the time
to 0 hours. Press WARM or START BREW to
set the new time.
3. Next, the clock will display the current
warming plate temperature. To keep the same
temperature, press WARM or START BREW. To
change the temperature, turn the dial and press
WARM or START BREW for the temperature
to lock in. The unit will beep signifying that the
time and temperature has been set.
NOTE: If you set the warming time to
0 hours, Keep Warm will not automatically
activate during or after a carafe brew cycle,
but you can still turn it on manually by
pressing the WARM button.
NOTE: The time adjustment setting will be
saved and will not reset when the brewer is
unplugged or loses power.

SETTING THE DELAY BREW

(Grounds Mode Only)
1 Plug the brewer in and turn it on by pressing
the Power button.
NOTE: The clock will remain on even if the
brewer is turned off. Ensure the brewer is
powered on to set Delay Brew.
2 After filling the water reservoir and adding
ground coffee to the filter, place the
appropriate-size vessel under the brew basket.
3 Press the Grounds Button to enter grounds
mode. Press DELAY. The clock will begin to
flash "12:00" or the previous time set.
4 While the clock is flashing, turn the dial to
adjust the hour. The AM or PM indicator will
illuminate under the clock display as you are
setting the desired time. Press START BREW
to lock in the hour. Now, turn the dial to adjust
the minute. Press START BREW to lock in your
time.
5 Next, turn the dial to select the size that you
would like to brew.
6 Press the Grounds button to choose your brew
style.
7 Once the time, brew size, and brew style have
been set, press the dial to activate. When
activated, the brewer will beep and DELAY and
your selected options will remain illuminated.
To view your set delay brew time, press and
hold the DELAY button. To cancel, press the
DELAY button or power off the unit.
NOTE: The brewer must remain on for
the Delay Brew function to work.
DO NOT power off or unplug after setting
Delay Brew. If the brewer is turned off or
unplugged, delay brew will need to be reset.
NOTE: When delay brew is set, a grounds
brew cannot be run until the delay brew has
finished or has been canceled. A capsule
brew may be run at any time up until
5 minutes before the preset brew time.
ninjakitchen.ca 11