Subscribe to Our Youtube Channel
Related Manuals for MTI RU-888-0
Summary of Contents for MTI RU-888-0
- Page 1 MTI RU-888-0 RFID Module User Manual Version 4.0 MTI Group Proprietary Information Any unauthorized use, duplication, reproduction, or disclosure of this document may be considered as infringement of MTI Group’s intellectual...
- Page 2 Content 1. Start Demo SW 2. Advanced Reader Setting 3. Inventory Run 4. Advanced Tag Setting...
- Page 3 WARNING：Please keep more than 20 cm away when doing the test. 1. Start Demo DW 1. 1 Double click the icon as in Fig.1 Fig.1 Online Plug Antenna and USB cable you could see the Demo SW shown as in Fig.2 Fig.2...
- Page 4 2. Advanced Reader Setting 2. 1 Right click the MTI module and will show “Reader Setting ” on screen. You could start to set the region, frequency, and output power as in Fig.3. Fig.3 Please you must set Region, Power Level, and choose Hopping in Frequency Column when you would like to do the normal test.
- Page 5 would like to set another value. Fig.4...
- Page 6 3. Inventory Run 3. 1 After setting the parameter, please press “ Start Scan “ to start the inventory run as shown in Fig.5 and Fig.6. Fig.5 Fig.6...
- Page 7 4. Advanced Tag Setting Please right-click on the tag that you would like to change the setting as shown in Fig.7. Fig.7 You could set EPC, Password, Lock, or Kill the selected tag in this window as shown in Fig. 8. Fig.
- Page 8 Reserved, EPC, TID, and User Bank at Memory Column. Choose the one you would like to know the information and press the Read Button as shown in Fig.9. Fig. 9 You could see this kind of picture as in Fig. 10 if MTI module could get complete information from the tag.
- Page 9 Fig. 10 b. You could see this kind of picture as in Fig. 11 if MTI module couldn’t get complete information from the tag. Fig. 11...
- Page 10 4.4 Please read user bank if you would like to write any information into user bank. Write the information into the byte you would like to modify and press Set button as shown in Figure 12. Fig. 12 GUI would shown pass message as shown in Fig.
- Page 11 The final end product must be labeled in a visible area with the following" Contains TX FCC ID: MAD-RU-888-0 ". The FCC part 15.19 statement below has to also be available on the label: This device complies with Part 15 of FCC rules.
Need help?
Do you have a question about the RU-888-0 and is the answer not in the manual?
Questions and answers