Table of Contents
Advertisement
Connecting the presence detector
Connection (230 V AC)
KNX
KNX
N
L
!
Secure device with an upstream type B or type C circuit
breaker (EN 60898-1) with a maximum of 16 A.
!
Risk of electric shock!
The device does not have basic insulation around the
terminals!
Protect against accidental contact during installation.
†
Maintain a minimum distance of 3 mm from live parts or
†
use additional insulation, e.g. separating strips/walls.
!
Do not connect mains voltage (230 V) or other external
voltages to the extension inputs!
Failure to comply with this instruction may result in
death or serious injury!
!
During installation, ensure there is adequate insulation
between mains voltage (230 V) and bus or extensions
(min. 5.5 mm).
Disconnect power source.
†
Connection (24 V DC/KNX auxiliary voltage)
KNX
KNX
+
+
–
–
24 V DC
–
+
!
Risk of electric shock!
The device does not have basic insulation around the
terminals!
!
The additional supply voltage can only be carried in the
KNX bus cable when using the safety extra-low voltage
SELV (e.g. KNX auxiliary voltage).
Disconnect power source.
†
5. Installation and detection area
There are 3 ways to mount the presence detector at the
ceiling:
– Flush mounting
– Ceiling installation
– Surface mounting
L Observe the recommended installation height of
2.5 m – 4.5 m!
L When installing several devices, keep a minimum distance
of 2 m!
2 m
L Ensure a sufficiently large field of vision so that motion
and the presence of people will be correctly detected.
L Avoid suspended lamps or partition walls, etc.
Flush-mounted installation
with a standard flush-mounting box, size 1 (installation ope-
ning Ø 60 mm, max. installation depth 37.5 mm)
Lock
5,25
4
3
2
1
TOP
TOP
zone 1–6
2
Advertisement
Table of Contents
