Table of Contents
Advertisement
Available languages
Available languages
MAINTENANCE
CLEANING YOUR WINE CELLAR
• Turn off the power, unplug the appliance, and remove all items including shelves and rack.
• Wash the inside surfaces with warm water and baking soda solution. The solution should be about
30 ml (2 tbsp) baking soda to 1L (1 quart) of water.
• Wash the shelves with a mild detergent solution.
• Wring excess water out of the sponge or cloth when cleaning area of the controls, or any
electrical parts.
• Wash the outside cabinet with warm water and mild liquid detergent.
• Rinse well and wipe dry with a clean soft cloth.
POWER FAILURE
Most power failures are corrected within a few hours and should not affect the temperature of your
appliance if you minimize the number of times the door is opened. If the power is going to be off for
a longer period of time, you need to take the proper steps to protect your contents.
VACATION TIME
• Short vacations: Leave the Beverage Centre operating during vacations of less than three weeks.
• Long vacations: If the appliance will not be used for several months, remove all items and turn off
the appliance. Clean and dry the interior thoroughly. To prevent door and mold growth, leave the door
open slightly, blocking it open if necessary.
MOVING YOUR WINE CELLAR
• Remove all items.
• Securely tape down all shelves inside your appliance.
• Turn the adjustable leg up to the base to avoid damage.
• Tape the door shut.
• Be sure the appliance stays secure in the upright position during transportation and protected on
the outside of the appliance with a blanket, or similar item.
ENERGY SAVING TIPS
The Wine Cellar should be located in the coolest area of the room, away from heat
producing appliances, and out of the direct sunlight.
CHARCOAL FILTRATION SYSTEM
Your wine is a living object that breathes through the cork of its bottle. In order to preserve the quality
and taste of your fine wines, they must be stored at the ideal temperature and ambient conditions.
Your wine cooler is equipped with an active charcoal filtration system to ensure air purity, cooling
efficiency, and to maintain an odor free cabinet for the storage of your fine wines.
TO REPLACE FILTER
1. Remove the bottles of wine stored on the top 2 shelves.
2. Remove the shelves.
3. Press in the filter slightly and turn it 45 degrees
counter-clockwise, then remove it.
5. Place the new filter in and turn it 45 degrees
clockwise to lock on place.
WARNING! This product contains chemicals known to
the State of California to cause cancer, and birth defects
or other reproductive harm. www.P65Warnings.ca.gov
to unlock
6
TROUBLESHOOTING GUIDE
You can solve many common appliance problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
POSSIBLE CAUSE
Appliance does not operate.
Not plugged in.
The circuit breaker tripped or a blown fuse.
Appliance is not cold enough.
Check the temperature control setting.
External environment may require a higher setting.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
The compressor turns on and
The room temperature is hotter than normal.
The door is opened too often.
off frequently.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
In order to circulate the air and maintain the set temperature
The fans turn on and off
frequently.
inside the cabinet the fans must cycle on and off even when
the compressor is off. The fans will cycle ON and OFF while
the compressor is off approximately every 10 seconds, this
is called "Semi-speed status". This cycle is normal and meant
both to circulate the air as well as ensure the continued
operational status of the fans. If the fan stops completely
and does not complete this cycle the fan is non-operational.
The light does not work.
Not plugged in.
The circuit breaker tripped or a blown fuse.
The bulb has burned out.
Vibrations
Check to assure that the appliance is level.
The appliance seems to make
Contraction and expansion of the inside walls may cause
too much noise.
popping and crackling noises.
The appliance is not level.
The door will not close properly.
The appliance is not level.
The door was reversed and not properly installed.
The gasket is dirty.
The shelves are out of position.
Moisture build up o
This is normal during high humidity periods.
n the interior
The room temperature is hotter than normal.
The door is opened too often.
or exterior of the unit
The door gasket does not seal properly.
Error Code:
A sensor has failed. Contact Koolatron Customer Service.
E1-E2-E3-E4-E7-E8
7
Advertisement
Table of Contents
