Connecting To The Drain; Adjusting The Feet - Beko DS 7435 RX0 User Manual

Installation

3.3 Connecting to the drain

In products equipped with condenser unit,
water accumulates in the water tank during
the drying cycle. You should drain accumu-
lated water after each drying cycle.
You can directly drain accumulated water
through the water drain hose supplied with
the product instead of periodically draining
the water collected in the water tank.
Connecting the water drain hose
1-2 Pull hose at the behind of the dryer
by hand in order to disconnect it from
where it is connected. Do not use any
tools to remove the hose.
3
Connect one end of the drain hose
supplied with the dryer to the
connection point from where you
removed the hose of the product in
previous step.
4 Connect the other end of the drain hose
directly to the wastewater drain or to
the washbasin.
1
3
Dryer / User Manual
2
4
A
Hose connection should be made
in a safe manner. Your drain
house will be flooded if the hose
comes out of its housing during
water discharge.
C
Water drain hose should be
attached to a height of maximum
80 cm.
C
Make sure that the water drain
hose is not stepped on and it is
not folded between the drain and
the machine.

3.4 Adjusting the feet

• In order to ensure that the dryer
operates more silently and vibration-
free, it must stand level and balanced
on its feet. Balance the machine by
adjusting the feet.
• Turn the feet to left or right until the
dryer stands level and firmly.
C
Never unscrew the adjustable
feet from their housings.
45 / EN