Maintenance - Craftsman CMXGWAS021024 Operator's Manual

Table of Contents

Advertisement

Available languages

Available languages

Maintenance

Maintenance Schedule
Follow the hourly or calendar intervals, whichever occurs
first .
Every 8 Hours or Daily (see Operation Section)
• Check engine oil level
• Clean debris
• Lubricate o-rings
• Check spray gun
• Check high pressure hose
• Check / clean water inlet screen
• Check detergent siphoning tube
Every 25 Hours or Yearly
• Clean engine air filter and pre-cleaner
Every 50 Hours or Yearly
• Change pump oil
• Change engine oil
• Service exhaust system
Yearly
• Replace spark plug
• Replace engine air filter and pre-cleaner
• Service cooling system
1
Service more often under dirty or dusty conditions .
2
See any authorized dealer for service .
General Recommendations
Regular maintenance will improve the performance and
extend the life of the pressure washer . See any authorized
dealer for service .
Pump Oil Maintenance
1 . Clean around oil drain plug at bottom of pump,
remove plug and drain oil completely .
Pump Oil Drain
2 . Reinstall oil drain plug and tighten firmly .
3 . Clean area around pump oil dipstick and remove
dipstick . Fill pump with SAE 30 weight oil
(approximately 10 oz . (0 .3 liters)) to the point of
overflowing .
4 . Install pump oil dipstick and wipe up any spilled oil .
12
1
1, 2
Detergent Siphoning Check Ball
The check ball in detergent siphoning system may become
stuck from dried soap or minerals in water . The check ball
can be freed by performing the following:
WARNING! Chemical Burn Hazard . Chemicals
could cause burns resulting in death or serious
injury . Follow chemical manufacturer's label
instructions for proper use and handling of the chemical .
Following Shut Down, remove detergent siphoning hose
from barbed fitting on pump .
1 . Insert paper clip, or similar device, into barbed fitting
on pump and push down until ball moves .
2 . Reinstall detergent siphoning hose .
Spray Tip Maintenance
Clean an obstructed spray tip to correct a pulsing
sensation when squeezing the spray gun trigger .
1 . Following Shut Down, remove spray tip from spray
wand .
2 . Use a paper clip, or similar device, to free foreign
material .
Craftsman.com

Advertisement

Chapters

Table of Contents
loading

Table of Contents