Table of Contents
Advertisement
DRILLING SAFETY
WARNING
!
• Inspect the area to be drilled before operation. Remove objects which can be thrown or be-
• Keep all parts of your body away from the drilling bit when operating the unit.
• DO NOT operate the PRO-DIG
• While the auger bit is rotating, DO NOT attempt to manually guide the auger to a location.
UNDERGROUND HAZARDS
WARNING
!
It is the responsibility of the operator to know where buried power, gas, telephone, and other utili-
ties are in the work area. This may lead to shock or an explosion. Have the work area marked for
buried lines and do not dig in marked areas set by your local municipals. Striking a hard object
underground with the auger turning can result in the slowing or stopping of the auger.
!
SAFETY DECALS
This unit comes equipped with all safety decals in place. They are designed to help you safely
operate your unit. Read and follow all safety decals.
(Locations shown below in figure 1)
• Keep all safety decals clean and legible at all times
• Replace safety decals that are missing or have become illegible.
• Safety decals are available from your distributor or manufacture.
• Some parts installed during repair may require safety decals to be affixed to the replacement
!
INSTALLING SAFETY DECALS
• Clean the desired are with warm soapy water.
• Decide on exact position before your remove the backing paper.
• Peel backing paper from decal. Press firmly on the surface.
• Air pockets can be pierced with a pin and smoothed.
785.856.2661
GENERAL PRECAUTIONS
come entangled.
above ground. The auger bit may bind and cause injury to the operator and damage to the
equipment.
SAFETY DECAL LOCATIONS
part. When ordering the replacement part(s) be sure the correct safety decal(s) are included in
your order.
Auger Drive when the auger bit is more than 12" (305mm)
®
(cont.)
5.
Advertisement
Table of Contents
