Wireless Wan Card (For Selected Thinkpad Z13 Gen 2 Models) - Lenovo ThinkPad Z13 Gen 2 User Manual

Notes:
• Remove or install the M.2 solid-state drive bracket by pulling the transparent tab as shown below. Do not
pull the bracket directly. When installing, tighten the screw on the transparent tab.
• lf the M.2 solid-state drive bracket is deformed, correct it to proper shape before installing.
• A mylar film might cover the M.2 solid-state drive bracket. To access the M.2 solid-state drive, peel off the
mylar film first. Do not damage the mylar film and attach it in place after replacing the drive.
• There might be thermal pads on the top and the bottom of the M.2 solid-state drive. Ensure that the
thermal pad under the M.2 solid-state drive stays in its place after replacing the drive.
Removal procedure (for ThinkPad Z16 Gen 2)

Wireless WAN card (for selected ThinkPad Z13 Gen 2 models)

The following information is only for the computer with user-installable modules. Ensure that you use only a
Lenovo-authorized wireless module specifically tested for this computer model. Otherwise, the computer will
generate an error-code beep sequence when you turn on the computer.
Prerequisite
Before you start, read
Generic Safety and Compliance Notices
Attention: Do not touch the contact edge of the wireless WAN card. Otherwise, the wireless WAN card
might get damaged.
For access, do the following:
1. Disable the built-in battery. See "Disable the built-in battery" on page 39.
and print the following instructions.
Chapter 6
. 43
CRU replacement