Table of Contents
Advertisement
Quick Links
Note: The following instructions will serve as a start-up programming base for the installation of a Sprite TL in Push Button
Mode.
1. Get into Programming Menu
•
To enter the programming menu press and hold the
•
The display will show 000 with the left 0 flashing.
•
Press the
key to change the digit to a 1.
•
Press the
key to advance to the middle digit.
•
Press the
key 2 times to change the digit to a 2.
•
Press the
key to advance to the right digit
•
Press the
key 3 times to change the digit to a 3.
•
With the display showing 123 press the
Quick Start Guide
Push Button Mode
key for 2 seconds.
key.
Sprite TL
1
Advertisement
Table of Contents
Summary of Contents for Hydro Sprite TL
- Page 1 Quick Start Guide Sprite TL Push Button Mode Note: The following instructions will serve as a start-up programming base for the installation of a Sprite TL in Push Button Mode. 1. Get into Programming Menu • To enter the programming menu press and hold the key for 2 seconds.
- Page 2 2. Prime the Pumps and Operation Mode • The display will show P-1 with the 1 flashing. (pump 1) • Press the key to prime pump 1, press again to stop. • Press the key to select P-2 (pump 2). •...
- Page 3 6. Program Pump Delay Time • Press the key to display “d1” with the 1 flashing. (d1 = pump 1 delay time, d2 = pump 2 delay time). • Press the key to select a pump to delay. • Press the key to display delay time.
- Page 4 Hydro Systems Company Phone 513-271-88OO 3798 Round Bottom Road Toll Free 8OO.543.7184...
Need help?
Do you have a question about the Sprite TL and is the answer not in the manual?
Questions and answers