iCarsoft TPMS S2000 Quick Start Manual

w w w . i c a r s o f t . u s
iCarsoft TPMS S2000
Quick Start Guide
S2000
IMPORTANT: Read these instructions
carefully and use this unit properly before
operating. Failure to do so may cause
damage and/or personal injury and will
void the product warranty.
Installation Steps
1. Loosening the tire
Remove the valve cap and nut and deflate the tire.
Use the bead loosener to break the tire bead.
Caution: The bead loosener must be facing the valve.
2. Dismounting the tire
Clamp the tire on the tire changer,
and adjust the valve at 1 o'clock to
the tire fitting head. Use the tire
tool to dismount the tire bead.
Caution: Always observe this starting point during the whole
dismounting process.
English
Safety Instructions
Any maintenance and repair work must be carried out by trained
experts. Failure to do so may result in the failure of the TPMS
sensor. iCarsoft does not assume any liability in case of faulty or
incorrect installation of the unit.
CAUTION
When mounting/dismounting the wheel, follow the operation
guideline of wheel changer manufacturer strictly.
Do not race with the vehicle on which the LTR-01 RF
sensor is mounted, and always keep the drive speed under
240km/h.
To guarantee optimal performance, the sensors may only
be installed with original valves and accessories provided
by iCarsoft.
Make sure to program the sensors using iCarsoft-specific
TPMS tool prior to installation.
Do not install programmed TPMS sensors in damaged
wheels.
After installing the TPMS sensor, test the vehicle's TPMS
following the steps described in the original manufacturer's
user manual to confirm proper installation.
3. Dismounting the sensor
Remove the cap and nut from the valve
stem, and then remove the sensor
assembly.
4. Mounting the sensor and throttle
Step 1. Remove the cap and nut from
the valve stem.
Step 2. Place the valve stem through the valve hole of the rim,
ensuring the sensor body located on the inside of the rim.
Assemble the nut back on the valve stem with a torque of 4N·m,
then tighten the cap.
Caution: Make sure that the nut and cap are installed on the
outside of the rim.
Components & Controls
Cap
Valve core assembly
Sensor body
Technical Parameters
Weight 29g
Dimension(L*W*H) About 77.5*40*15mm
IP Rating IP67
When replacing or servicing the sensor, please only use the
original valves and accessories provided by iCarsoft to ensure
proper sealing. It is mandatory to replace the sensor if it is
externally damage. Always remember to tighten the nut to the
correct torque of 4N·m.
5. Remounting the tire
Place the tire on the rim, ensure that the valve starts on the
opposite side of the rim from the tire fitting head. Mount the tire
over the rim.
Caution: Strictly follow tire changer manufacturer's instructions
to mount the tire.
Warranty
The sensor is guaranteed to be free from material and
manufacturing defects for a period of twenty-four (24) months or
for 31000 miles, whichever comes first. This warranty covers any
defects in materials or workmanship under normal use during the
warranty period. Excluded from the warranty are defects due to
improper installation and usage, induction of defect by other
products, damage due to collision or tire failure.
Screw