Incubator Warehouse Little Giant 9300 Installation Instructions

11. Install Modifi ed Heating Element into Incubator
Reinstall the modifi ed heating element into the incubator using the original
screws and washers .
(image 18)
dent or tear the incubator lid.
cord back into slot 1H and the red and black fan cord into slot 3F
Note: Push the fan wire into the plug as far as you can using your fi ngers,
then use a small fl athead screwdriver to pop it into place.
Additional Resources
Video Installation Guide
https://incubatorwarehouse.com/little-giant-9300-fan-with-installation-guide.html
and scroll to the bottom of the listing.
Need additional help? Please feel free to contact us.
Email: service@incubatorwarehouse.com
Phone: 208-740-1344
Facebook:
www.facebook.com/IncubatorWarehouse/
4
Caution: Overtightening screws can
Plug the black and white heating element
Go to
QR Code
L i t t l e G i an t 9 3 0 0 In cu b a t o r F an
I n s t al l at i o n In s t r u ct i o ns
.
(image 19)
Package Contents
Included Items:
• Incubator Warehouse Fan
• Replacement Fan Cover
• Super Glue
Items Needed:
• Little Giant 9300 Still Air Incubator
• Phillips Screwdriver
• Small Flathead Screwdriver
• Scissors
(or other cutting tool)
Installation
1. Disconnect Cord
Remove lid from incubator. On the
bottom of the lid, disconnect the
black and white wire for the heating
element from the hole labeled "1H"
.
(image 1)
2. Remove Heating Element
While supporting the heating
element, unscrew the two
mounting screws on the top side
of the incubator
the heating element from the
incubator, and set the incubator
aside. Important: save screws and
washers.
3. Glue Heating Element
Place the heating element screw side
down . Apply the super glue
(image 3)
to the ends of the heating element
assembly pegs ensuring that they
are covered
(image 4)
the heating element from falling
apart when the cover is removed.
Ensure super glue is dry before
moving on to the next step.
Video Installation Guide
https://incubatorwarehouse.com/
little-giant-9300-fan-with-installation-
and scroll to the bottom of the listing.
, remove
(image 2)
. This prevents
by
guide.html
QR Code
Push tab towards
wires to disconnect
and unplug.
image 1
image 2
image 3
image 4