Zanussi ZNFE18ES3 User Manual page 15

Problem
There is too much condensed
water on the rear wall of the re-
frigerator.
Water flows inside the refriger-
ator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli-
ance is too low/too high.
Possible cause
Door was opened too fre-
quently.
Door was not closed com-
pletely.
Stored food was not wrapped.
Food products prevent the wa-
ter from flowing into the water
collector.
The water outlet is clogged.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The FastFreeze function is
switched on.
The temperature is not set cor-
rectly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened of-
ten.
The FastFreeze function is
switched on.
There is no cold air circulation
in the appliance.
Solution
Open the door only when nec-
essary.
Make sure the door is closed
completely.
Wrap food in suitable packag-
ing before storing it in the ap-
pliance.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet
to the evaporative tray.
Switch off FastFreeze function
manually, or wait until the func-
tion deactivates automatically
to set the temperature. Refer
to "FastFreeze function" sec-
tion.
Set a higher/lower tempera-
ture.
Refer to "Closing the door"
section.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Refer to "FastFreeze function"
section.
Make sure that there is cold air
circulation in the appliance.
Refer to "Hints and tips" chap-
ter.
15