ScanCool MWP 25 User Manual page 17

11. Programming Mode
This mode allows the user to assign cook times and power levels to the once touche button.
1) Open the door and press "1" for 5 seconds,the buzzer will sound once and enter to
Programming Mode.
2) "ProG" displays.
3) Press any number ,0 to 9,and the LED will display the saved time, then you can input
the time you need.
4) Press " ","
LED will display the related power. If the same button pressed twice, the power
will change to PL10. If no power chosen, "PL10" is default.
5) To change the cooking fators: If press "X2",LED will display "CF:XX". The default factor is
80%. "CF:80" displays. If you need to change the cooking power, just press one of
the number buttons to set.
6) After setting the time and power, press "
When the program saved, "ProG" displays.
7) If all the cooking time exceeds the MAX.time User Option 7, when press
" " to save the program, the buzzer will sound three times briefly
is no use. And then LED turn back to show "ProG". The time set before will be no change.
8) Close the door, the oven will turn back to Ready Mode.
If press "
The program that not saved will be lost. If there is program saved as memory procedure,
press the related number button, the saved program will start. If no saved program,
the buzzer will alarm when pressing number button and it will not work.
For example: set the program as memory cooking.
Program; Power level PL7 and cooking time is 1 minute and 25 seconds.
Step 1: In ready state, press number button "1" for 5 seconds,"ProG" displays.
Step 2: Press number button "3", the program will be saved in "3".
Step 3: Press number buttons "1", "2" and "5" to input the cooking time.
Step 4: Press "
Step 5: Press "
the related program will start.
Note:
1. If the electricity is cut off, the saved program will not lost.
2. If the program need to reset , just repeat the aboved steps.
3. If press " " at the last step, it will turn back to Ready Mode. The setting will be no use.
"," " or "
" button during setting process, the oven turn to Door Open Mode.
" button," PL7" displays. Setting finished.
" to save. When use the program next time, just press "3",
" to input the power level.
" in 30s, the cooking program will be saved.
17
to tell you the time