Subscribe to Our Youtube Channel
Summary of Contents for EGi EJ520
- Page 1 Original Manual_NL User manual Petrol earth auger 4-stroke (one person) EJ520 Original instructions This user manual should be kept with the earth auger. EGI EJ520...
- Page 2 Original Manual_EN This page is intentionally left blank. EGI EJ520...
- Page 3 Wear anti-vibration safety gloves Do not use the machine in the rain Do not lean on the machine Do not use the earth auger if children are nearby Be aware of the rotating drill! High risk of injury! EGI EJ520...
-
Page 4: Owner's Responsibility
If the earth auger stops: turn off the engine and allow it to cool down before removing it manually. Use only Aspen 4 or euro 95. Do not mix oil and petrol. EGI EJ520... - Page 5 - Make sure the engine does not run out of fuel. - Drain all fuel from the machine before transport. - Store the machine in a well-ventilated environment with an empty tank. - For specific information regarding the Honda GX35 engine, please refer to the Honda owner’s manual. EGI EJ520...
- Page 6 - Keep hands and feet away from a rotating earth auger. - Make sure that the engine is off and the spark plug has been removed before making any adjustments. - Check before use if any parts are worn or damaged. Replace them if necessary. EGI EJ520...
- Page 7 Place the machine on its side with the throttle down. Remove the dipstick from the engine, insert a funnel, fill the sump with oil and replace the dipstick. Please note the maximum filling level. Figure 2 – Dipstick on the engine EGI EJ520...
-
Page 8: Filling The Tank
Bear in mind that the fuel system is completely empty before first use and will have to be run in. The engine will start once the fuel system has been filled. The machine will start more easily next time. EGI EJ520... - Page 9 Release the throttle to stop the auger rotating. Figure 5 – ON/OFF switch Hold the machine firmly with one hand. With the other hand grip the pull starter. (Fig. 6) Figure 7 – Throttle EGI EJ520...
- Page 10 Remove sand and debris from the auger and check for damage before drilling a new hole. Switch off the engine (Fig. 8) Release the throttle and push the ON/OFF switch to the “OFF” position. (Fig. 8) Figure 8 – ON/OFF switch EGI EJ520...
-
Page 11: Maintenance
The spark plug must be removed after every 10 hours of use. Check the colour of the dirt on the end of the spark plug, it should be a tan colour. Remove all the dirt with a wire brush. Check the electrode gap and adjust if necessary. The correct distance is 0.7 to 0.8 mm (Fig. 9). EGI EJ520... - Page 12 ON/OFF switch to “OFF”, pull the pull starter a few times gently. Replace the spark plug and pull the pull cord until you feel resistance. Then stop pulling. 3. Store the earth auger in a dry, well-ventilated place. Cover the machine so that no dust or other dirt can accumulate in the machine. EGI EJ520...
-
Page 13: Disposal Instructions
Set the correct position or if faulty or damaged. contact a specialist dealer. If these measures do not solve the problem or if there are other faults not shown here, do not hesitate to contact EuroGate International or your dealer. EGI EJ520... -
Page 14: Technical Specifications
EJ520-200 EJ520-250 EJ520-300 Auger weight The noise level may exceed 85dB(A), therefore ear defenders are required. Wear anti-vibration work gloves EGI contact details EuroGate International B.V. Galileistraat 6 7701 SK Dedemsvaart The Netherlands Tel: +31 (0) 523 638 286 parts@eurogate-international.com... -
Page 15: Ec Declaration Of Conformity
EC Directives. Description: Petrol earth auger machine Machine model: EJ520 Trademark: Consumption/cylinder capacity 35 CC Relevant EC Directives EC Machinery Directive (2006/42/EG) EC Directive on Electromagnetic Compatibility (EMC) Manufacturer’s signature Manufacturer’s stamp EGI EJ520... - Page 16 Original Manual_EN This page is intentionally left blank. EGI EJ520...
Need help?
Do you have a question about the EJ520 and is the answer not in the manual?
Questions and answers