Table of Contents
Advertisement
7.
Check the front-to-rear blade level
Ensure the front blade tip is lower than the rear
blade tip as shown in the block height and rake
table. If adjustment is needed, continue with this
procedure.
Figure 87
1. Blades front to rear
2. Blade tip
8.
Set the anti-scalp rollers to top holes or remove
them completely for this adjustment.
9.
Raise the deck to the transport position (140 mm
or 5-1/2 inches).
10.
Slowly loosen the adjusting screw on the
lift-assist spring until you can remove the screw
(Figure
88).
Note:
Save the screw for installation.
(Figure
87).
g037880
3. Measure from the tip of the
blade to the flat surface
here.
1. Adjusting screw
2. Bracket
11.
Place 2 blocks (see Block Height and Rake
Table) under the rear edge of the cutting deck
skirt; 1 on each side of the cutting deck
89).
12.
Set the height-of-cut lever to the 76 mm (3
inches) position; refer to
of Cut (page
29).
13.
Place 2 blocks under each side of the front edge
of the deck, but not under the anti-scalp roller
brackets or welds.
1. Block—73 mm (2-7/8
inches)
65
Figure 88
3. Set the gap to 22 to 29
mm (7/8 to 1-1/8 inches).
Adjusting the Height
Figure 89
Bottom view
2. Welds
g334850
(Figure
g038090
Advertisement
Table of Contents
