Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for MAG THEATRON TDC Series
- Page 1 User manual THEATRON TDC series Power amplifiers Models: TDC-1200W TDC-3200W...
-
Page 2: Table Of Contents
9.1. About MAG Cinema macroprotocol ..........................26 9.2. Sending the amplifier rack up for remote communication ................26 9.3. Macroprotocol syntaxis ..............................26 9.4. Macroprotocol commands ............................... 26 9.5. Finish markers..................................26 10.1. Product warranty ................................28 10.2. Assistance ....................................28 TDC series user manual rev 1.0... -
Page 3: Panel A. Dimensions
Panel A. Dimensions TDC series user manual rev 1.0... -
Page 4: Panel B. Specifications
2x RCA unbal. input, 2x XLR female bal. input, 2x XLR male bal. output, Connectors 4-pin Phoenix speaker terminal, RJ-45 Ethernet Dimensions (W×H×D) 486 x 88 x 294 mm, 2U Net weight 5,25 kg 5,9 kg TDC series user manual rev 1.0... -
Page 5: Panel C. Front And Rear Panels
G. Channel 2 selection button. 9. Channel 1 balanced XLR male through 1. Mains switch. connector. 2. Mains plug. 10. Channel 2 balanced XLR male through 3. Output Phoenix connector. connector. 4. Channel 1 unbalanced RCA input. TDC series user manual rev 1.0... -
Page 6: Panel D. Audio And Ethernet Connection
Panel D. Audio and Ethernet connection Input connectors, balanced Input connectors, unbalanced Through connectors, balanced TDC series user manual rev 1.0... - Page 7 Loudspeaker connection, stereo mode Loudspeaker connection, bridged mode 568A 568B ETH port in ETH TX+ GREEN/WHITE ETH TX- GREEN ETH RX+ ORANGE/WHITE not connected BLUE not connected BLUE/WHITE ETH RX- ORANGE not connected BROWN/WHITE not connected BROWN TDC series user manual rev 1.0...
-
Page 8: Panel E. Menu Structure
DSP menu(5-10) AllCopy 1 to 2 ? Copy all six EQ bands from channel 1 to channel 2 AllCopy 2 to 1 ? Copy all six EQ bands from channel 2 to channel 1 TDC series user manual rev 1.0... - Page 9 Ch 1 U.Name < > Edit the unit name Go To 1 ----Exit--- 6- Password Input Password three-level password protection [OPEN] >000000< OPEN first level functions are available all functions are available password protection enabled TDC series user manual rev 1.0...
- Page 10 TDC series user manual rev 1.0...
-
Page 11: Safety Instructions
ONLY BY QUALIFIED TRAINED PERSONNEL REQUIREMENTS OF THE COUNTRIES WHERE FOLLOWING APPLICABLE SAFETY RULES. THE UNIT IS SOLD. DO NOT ALLOW INSTALLATION OF THIS UNIT IF INSTALLATION HARDWARE IS BROKEN, BENT, PARTS ARE MISSING OR IS OTHERWISE DAMAGED. TDC series user manual rev 1.0... -
Page 12: Regulatory Information
EN 61000-4-2:2009 technician for help. EN 61000-4-3:2006 /A1:2008 /IS1:2009 /A2:2010 EN 61000-4-4:2012 EN 61000-4-5:2006 EN 61000-4-6:2014 EN 61000-4-11:2004 EN 60065:2002 /A1:2006 /A11:2008 /A2:2010 /A12:2011 Bila Tserkva, 18 Aug 2023 Alexey Asanov For compliance questions: info@mag-audio.com TDC series user manual rev 1.0... -
Page 13: Tdc Series
Congratulations buying your Theatron TDC series amplifier. Before you get started, Your MAG amplifier has been completely tested please read this user’s manual and safety instructions. and inspected before leaving the factory. Carefully In case you have any questions, please do not hesitate inspect the shipping package before opening it, to contact your dealer of MAG Theatron. -
Page 14: Installation
Normal operation is resumed automatically without the need for user intervention. TDC series amplifiers are equipped with a magnet- In case a rack with closed back panels is used, leave held front panel. Pull the front panel to remove it, and one rack unit empty for every four installed amplifiers retrieve the vent filter. - Page 15 - To avoid electrical shock, do not touch any exposed ground connection. speaker wiring while the amplifier is operating. The TDC series amplifiers have an automatic power - Do not spill water or other liquids into or on the factor correction system - PFC - for a perfect mains amplifier.
-
Page 16: Connections
TIA/EIA-568-B, i.e. T568B (refer 5.4. Analog balanced output (through) Panel D). Balanced analog outputs for sending the signal to another amplifier are provided with two XLR male connectors. Refer to Panel D for proper pinouts. TDC series user manual rev 1.0... -
Page 17: Front Panel
Pressing any of the Channel select buttons opens the Channel menu for that channel. Pressing both Channel buttons at the same time opens a Channel menu for controlling the parameters of both channels at the same time. TDC series user manual rev 1.0... -
Page 18: Menu Diagram
1 9 2 . 1 6 8 . 0 0 0 . 0 0 7 E n e r g y S a v e — O F F Screen 7: shows subnet mask. 7.3.2. METERS submenu TDC series user manual rev 1.0... -
Page 19: Network Submenu
Press the wheel to cycle N a m e E d i t o r █ N o ? through characters. — — — — — — — — — — — — — — — — TDC series user manual rev 1.0... -
Page 20: Password Submenu
— — — E X I T — — — █ — — — — M e t r i c — — — Select EXIT to discard changes to channel input. 7.4.3. PHASE submenu TDC series user manual rev 1.0... -
Page 21: Input Gain Submenu
Qu: controls the bandwidth of the PEQ band. 7.4.7. DELAY submenu Controls the delay of the selected channel. « D e l a y » D e l a y █ — 0 . 0 0 0 m TDC series user manual rev 1.0... -
Page 22: Default Ip, User Name And Password
8. Web UI 8.2. Connecting to the Web UI TDC series amplifiers provide a convenient Web UI to control all the settings of the amplifier. Enter the TDC amplifier IP address in the address bar of your browser. 8.1. Default IP, user name and password... -
Page 23: Source Window
It also gives access to the signal generator. 8.3.2. Channel windows Two windows for each output channel provide PEQ control, channel volume control, delay, and polarity inversion. TDC series user manual rev 1.0... -
Page 24: Monitoring Window
8.3.4. Config window The Config window contains various amplifier settings in four tabs. Amp config tab allows to give an amplifier the custom name, as well as create a custom name for each output channel. TDC series user manual rev 1.0... - Page 25 IP and dynamic IP mode. Misc config tab allows changing the MAC address and to set the custom username and password to access the device. Reboot tab allows to manually reboot the network adapter. TDC series user manual rev 1.0...
-
Page 26: About Mag Cinema Macroprotocol
9. Remote communication 9.1. About MAG Cinema macroprotocol 9.4. Macroprotocol commands TDC series amplifiers are capable for remote List of avaliable MAG Cinema macroprotocol control from PC, media server, or other device. commands, as well as possible values for them, are... -
Page 27: Product Warranty
If your MAG Cinema product needs repairs or maintenance, contact your official MAG Audio distributor / dealer. Please do not ship your MAG Cinema product without prior authorization. TDC series user manual rev 1.0... - Page 28 THEATRON 2 Merezhna str., Bila Tserkva, Kyiv region, 09100, Ukraine Tel./Fax.: +38 044 2774789 e-mail: info@mag-theatron.com www.mag-theatron.com...