TIE DOWN LongRun 86295 Installation Instructions

36" Center Section (1)
12" End Section (2)
Self Tapping Screws (3)

The Glide Ons are to be used on 2x6 bunk board lumber

without any carpeting between the Glide Ons and wood.
1. Remove any carpet or other covering materials from bunk
boards. Remove any brackets, screws, staples or other
materials in order to have a clean work surface on top and
both sides of the bunk boards.
2. Starting at the rear of the trailer, slide one of the 12" end
section Glide Ons onto the 2x6 lumber with the open side to
the front of the bunk board. Push the Glide On section onto
the lumber until it is almost flush with the end of the bunk
board (see Fig 1).
WARNING
Boat Glide On's greatly reduce friction between boat and trailer bunk boards. Winch must be locked and winch
line must be securely attached when launching, loading and transporting boat on trailer. Failure to keep boat
secured at all times to boat trailer can result in serious property damage, personal injury and/or possible death.
Prior to towing - always securely connect winch line, bow chain and transom tie down straps
Instruction Sheet #08096

Part 86295 - Kit contains the following components:

# Qty. Part #
1 4 46966
2 4 46964
3 48 10630

Part 86296 - Kit contains the following components:

# Qty. Part #
1 4 46966W
2 4 46964W
3 48 10630
WARNING WARNING
Description
Center Bunk Slide (Black)
12" End Bunk Slide (Black)
#10x3/4" Stainless Steel Self Tapping Screws
Description
Center Bunk Slide (White)
12" End Bunk Slide (White)
#10x3/4" Stainless Steel Self Tapping Screws
Fig. 1
Side View/Rear end
Glide On
Bunk Board
RIGHT
Slide Glide On UP
until it stops without
riding up the bunk
WARNING
WRONG
Page 1 of 2