Lenovo IdeaCentre B320 User Manual page 49

4. How can I tell if the wireless connection has been established successfully?
a. Check if the devices work: See if you can use the wireless keyboard and
mouse normally.
b. Check the indicator lights: Refer to section "C" of the "Indicator light guide".
5. Wireless keyboard and mouse connection instructions:
Connection
methods
Hardware method
Software method
Method 1: (Before starting the operating system)
1. Install the batteries, then turn on the power switches of the wireless keyboard
and mouse (if they have power ON/OFF switches).
2. Press the Connect buttons on the back of the keyboard and mouse.
3. When the keyboard and mouse wireless indicator lights blink, turn on the
computer. Press the Wireless Reset button on the chassis for 5 seconds or
longer until the indicator lights of the keyboard and mouse turn off.
4. Once the wireless connection has been successfully established, the wireless
keyboard and mouse will work properly.
Method 2: (Using the operating system)
1. Follow steps 1 and 2 from Method 1.
2. When the keyboard and mouse wireless indicator lights start blinking, turn the
computer on immediately.
3. After the operating system starts up, press the Wireless Reset button for 5
seconds or longer to search for wireless devices.
Note: This process could take several minutes.
4. The wireless mouse drivers will be installed automatically when the mouse is found.
5. When the wireless keyboard is found, enter the PIN code and press the Enter
key to complete the pairing process.
6. Once the wireless connection has been successfully established, the wireless
keyboard and mouse will work properly.
44
User Guide
31048832 IdeaCentre B3 UG V2.0 (EN)(R).indd 44
Description
Press the wireless reset button on
the chassis to connect the wireless
keyboard and mouse.
Connect the wireless keyboard and
mouse by adding devices in the
Hardware and Sound dialog box.
Instructions
Refer to Methods
1 and 2.
Refer to Method
3.
2010-12-24 10:10:48