Advertisement
Available languages
Available languages
4. Spare parts
Only original spare parts may be used.
Battery:
BAT6, BAT7, BAT8
Battery charger: BLG5, BLG6
5. Conduct in case of faults
In case of any fault, the Power Tool will be switched off and remain disabled. Th e service LED
will glow red or orange. You can proceed with your work only after the battery has been ex-
changed or removed for short time and is then re-inserted (RESET). If the malfunction persists
even after such a "reset", please contact after-sales service.
5.1 Codes of the operating/service LED display
LED-Display
after application (cycle)
steady green
fl ashing red/green
fl ashing red
steady red
steady orange
after power on (battery insertion)
steady green
steady orange
steady red
Th e fault massages can be read out using the analysis software. Please return the faulty work-
ing diagrams to our service center.
5.2 Codes of the supply voltage LED
LED-Display
after application (cycle)
fl ashing red
steady red
after power on (battery insertion)
steady green
steady red
12
Cause / remedy
Working value OK
Working value OK but service interval exceeded / Service
Working value is at the limit / contact the service center
Working value is outside range / return device to customer service
Temperature is outside the tolerance range /
cool or warm the device
Power tool is ready for operation
Temperature is outside the tolerance range /
cool or warm the device
Battery empty / change the battery.
Cause / remedy
Battery charge is below 10% / Change the battery.
Battery empty / change the battery.
Power tool is ready for operation
Battery empty / change the battery.
SPM32-18
Advertisement
