Playcore Swing N Slide NE 1539 Instruction Manual

Toddler Comfort Swing

Step 2:

Swing the T-Bar assembly open, away from the seat. With the T-Bar
in its fully open position you should have plenty of room to
comfortably place your child in the Swing Seat.
© PlayCore Inc. 2012
R R
NOTE: When hanging accessory next to other components, a minimum
clearance of at least 8" from adjacent swinging elements or any play equipment support structure is
required. Additional safety requirements including use zones apply. Consult your assembly instructions for
your particular Swing-N-Slide model.

Safety First:

• Installation of proper shock absorbing material is required. Consult the owner's manual of your original
Swing-N-Slide kit for depth requirements.
• Never leave occupant unattended in child seat.
• Always secure child with Lap Belt and T-Bar.
• Check moving parts and rope for wear at one month intervals.
• Do not allow children to play on equipment when it is wet.
• On-site adult supervision must be provided at all times.
• This is not a complete list of safety information. Consult the plan and guide of your original
Swing-N-Slide kit for a complete list of safety instructions.

Maintenance:

• Occasionally check to make sure water drainage holes remain unplugged. Clean them if necessary.
• Do not allow debris or loose materials to accumulate in seat.
• Periodically inspect cushions for wear, replace if torn or damaged.

Step 1:

1

Step 3:

3
With your fingers, reach underneath arm rests on each
side of seat and pull tabs outward, allowing the T-Bar to
pivot away from seat.
Strap the Lap Belt around your child's waist and securely
snap the buckle in place. The fit of the Lap Belt should be
snug, but not overly tight or constricting.
Note: The Lap Belt is always to be used when a child
is in the Swing Seat.
4
TB/NE 1539
2
LA 6190