Advertisement
Trouble shooting
Problem
The iron leaves a shine or an
imprint on the garment.
The appliance does not produce
any steam.
The appliance has switched off.
The light in the on/off button
flashes.
The appliance produces a
pumping sound and/or a
metallic rattling sound.
20
故障排除
Cause
The surface to be ironed was uneven, for
instance because you were ironing over a
seam or a fold in the garment.
There is not enough water in the water
tank (the 'water tank empty' light
flashes).
The appliance is not hot enough to
produce steam.
You did not press the steam trigger.
The water tank is not placed in the
appliance properly.
Automatic steam mode or speed mode
is off.
The auto-off function is activated
automatically when the appliance has
not been used for more than 10 minutes.
This is caused by the water being
pumped into the boiler inside the
appliance. This is normal and will be
more frequent for Speed and Auto
modes.
www.philips.com/support
Solution
PerfectCare is safe on all garments. The shine or imprint is not
permanent and will come off if you wash the garment. Avoid
ironing over seams or folds or you can place a cotton cloth over
the area to be ironed to avoid imprints at seams and folds.
Fill the water tank (see chapter 'Using your appliance', section
'Filling the water tank').
Wait until the 'iron ready' light on the iron lights up continuously.
Press the steam trigger and keep it pressed while you iron.
Slide the water tank back into the appliance firmly ('click').
If you prefer to use the automatic steam mode or speed mode,
ensure that the light indicator for the mode is lighted up on top of
the handle, and thereafter move your Philips Steam Generator Iron
to have steam.
Press the power on/off button to switch on the appliance again.
If the pumping sound continues nonstop, switch off the appliance
and remove the plug from the wall socket. Contact an authorised
Philips service centre.
Advertisement
