LG DLG4971 E Series Owner's Manual page 17

3. Reverse the components on the cabinet.
Hinge
cover
latch
mechanism
Hinge
a. Use a Phillips screwdriver to remove the two screws
and the latch mechanism on the front panel of the
cabinet.
b. Remove the latch hole cover by gently prying it
up with a flat blade screwdriver, being careful not
to scratch the paint. Install the latch hole cover on
the opposite side, where the latch mechanism was
removed. Install the latch mechanism in the position
from which you removed the latch hole cover, using
the two screws removed in step a.
c. Remove the hinge cover by gently prying it up with
a flat blade screwdriver, being careful not to scratch
the paint. Rotate the hinge cover 180 degrees and
install it on the opposite side, where the upper hinge
was attached.
d. Reverse the hinge and the hinge bracket at the
bottom of the cabinet. Remove the two screws from
the hinge bracket at the bottom right and remove
the hinge bracket. Remove the lower of the two
screws behind the hinge bracket. Do NOT remove
the upper screw behind the hinge bracket. Set the
parts aside.
CAuTiON
w
Do NOT remove any of the eight screws on the face of
the cabinet (marked below). Doing so could result in
damage to the dryer and the need for a service call to
repair the dryer.
e. Remove the three screws on the hinge at the
bottom left. Remove the hinge and reinstall it on the
right side. The top screw will occupy the hole where
you removed the screw behind the hinge bracket in
Upper
step d.
hinge
Latch hole
cover
Hinge
bracket
f. Install the hinge bracket removed in step d on the
bottom left side, first installing one screw behind the
hinge bracket.
latch hole
cover
hinge
bracket
ON THE DOOR:
4. Lift off the door cover.
With the door laid inside facing up on a protected
surface, remove the twelve screws on the inside
of the door. Carefully lift off the door cover with
the help of a small flat blade screwdriver inserted
in the upper corner (circled below).
WArNiNg
w
The edges of the door cover may be sharp. Take care
when handling, or wear gloves to avoid injury.
iNSTALLATiON iNSTruCTiONS
Cabinet Reversal complete
Twelve screws
Side
Hole
plug Interlock
button
17
hinge
cover
latch
mechanism
hinge