Bosch B26FT70SNS Operating And Installation Instructions page 10

en
Installing the handles
Do not install the handles until the
appliance is installed in its designated
location and is level.
All of the handles are identical.
The appliance comes with two sheets
of protective film that are used when
installing and removing the handles.
They can be used multiple times.
The sheets of protective film protect
the surface of the appliance when
installing and removing the handles.
NOTICE
If the handles are installed incorrectly,
they will not move in the right
direction.
To install the handles correctly:
It must be possible to push down on
the handles for the refrigerator
compartment doors.
It must be possible to push the
freezer compartment drawer handle
to the right.
1. Place the protective film on the
appliance.
10
2. Insert the refrigerator door handles
into the guides.
3. Push down on the handles until
they lock into place.
4. Insert the freezer compartment
drawer handle into the guides.
5. Push the handle to the right until it
locks into place.
6. Remove the protective film.
Removing the handles
1. Placement of the protective film:
S Above the guides on the
refrigerator doors.
S To the left of the guides on the
freezer compartment drawer.
2. Push down on the refrigerator
compartment door handles and
remove.
3. Push the freezer compartment
drawer handle to the left and
remove.
4. Remove the protective film. Save
the protective film for future use.
Installing the base plate
1. Remove the three screws on the
appliance.
2. Mount the base plate.
3. Insert the three screws and tighten.