Summary of Contents for THine THEIA-CAM THSCP101
- Page 1 THSCP101 Start Guide Rev. 1.00 THSCP101 Start Guide Rev. 1.00 www.thinesolutions.com | © THine Solutions, Inc. All rights reserved | inquiries@thinesolutions.com...
- Page 2 • THSCP101 • Camera board (THSCG101) • FFC cable • Adapter card ( ※ ) You can use the power supply included in the MediaTek Pumpkin i350 EVK. www.thinesolutions.com | © THine Solutions, Inc. All rights reserved | inquiries@thinesolutions.com...
- Page 3 THSCP101 Start Guide Rev. 1.00 2. PC Setup Step 1 : Install the software tools into PC. • Follow the steps in the web page of MediaTek. https://mediatek.gitlab.io/aiot/doc/aiot-dev- guide/master/sw/yocto/get-started/env-setup/flash-env- windows.html# www.thinesolutions.com | © THine Solutions, Inc. All rights reserved | inquiries@thinesolutions.com...
- Page 4 • Request the latest Linux binary to THine Solutions. https://www.thinesolutions.com/support-request Step 2 : Decompress as the Administrator mode • Decompress the THEIA-CAM_P101_i350 folder from .tar.gz file. • There is “i350-pumpkin” folder in the “THEIA- CAM_P101_i350” www.thinesolutions.com | © THine Solutions, Inc. All rights reserved | inquiries@thinesolutions.com...
- Page 5 Adapter Card THSCG101 ① Connect the adapter board with the Pumpkin i350 EVK. ② Connect the THSCG101 to adapter card with FFC. • Remove the cover on the camera module. www.thinesolutions.com | © THine Solutions, Inc. All rights reserved | inquiries@thinesolutions.com...
- Page 6 Connect HDMI display with “Micro-HDMI” via HDMI cable. ⑤ Connect PC with “DATA” port via USB Type-C cable. ⑥ Connect power outlet with “POWER” port AC adapter. Pumpkin i350 EVK power on. www.thinesolutions.com | © THine Solutions, Inc. All rights reserved | inquiries@thinesolutions.com...
- Page 7 Step 2 : Change the working folder to the folder where “i350-pumpkin” locates. Step 3 : Enter the following command to program the Linux binary to Pumpkin i350. • aiot-flash --load-dtbo video.dtbo --load-dtbo gpu-mali.dtbo --load-dtbo camera-thp7312-imx258-single.dtbo www.thinesolutions.com | © THine Solutions, Inc. All rights reserved | inquiries@thinesolutions.com...
- Page 8 “Looking for MediaTek SoC matching USB device 0e8d:0003” is shown in the prompt. Step 5 : Press “DOWN” then press “RST” button on the Pumpkin i350 EVK. Then release “RST” and “Down”button. www.thinesolutions.com | © THine Solutions, Inc. All rights reserved | inquiries@thinesolutions.com...
- Page 9 URL if you find that “aiot-flash” stops after you see "jumping to bootstrap" on the Command Prompt. https://mediatek.gitlab.io/aiot/doc/aiot-dev-guide/master/sw/yocto/get- started/flash/flash-troubleshoot-windows.html#missing-yocto-driver Step 7 : Remove USB cable from “DATA” port. www.thinesolutions.com | © THine Solutions, Inc. All rights reserved | inquiries@thinesolutions.com...
- Page 10 LPT)” & verify the correct port. • There should be “USB Serial Port (COM<N>)”. Step 3 : Launch “Putty” on your Windows PC, • You may need to install VCP driver. http://www.ftdichip.com/Drivers/VCP.htm • www.thinesolutions.com | © THine Solutions, Inc. All rights reserved | inquiries@thinesolutions.com...
- Page 11 Step 5: Fill in the connection settings as follows • COM<N> might be different from the following figure, but <N> should be the number checked in the Step 2. www.thinesolutions.com | © THine Solutions, Inc. All rights reserved | inquiries@thinesolutions.com...
- Page 12 Step 7: Login as "root“ • Enter “root”, then press enter key. Step 8: Reboot the Pumpkin i350 EVK and login as root. • Enter “reboot”, then press enter key. www.thinesolutions.com | © THine Solutions, Inc. All rights reserved | inquiries@thinesolutions.com...
- Page 13 1-3) Compare the firmware version You can go to section 7 if the firmware version in the hardware is the latest. Step 2: Shutdown and power off Pumpkin i350 EVK. www.thinesolutions.com | © THine Solutions, Inc. All rights reserved | inquiries@thinesolutions.com...
- Page 14 Step 3: Change the DIP switch(S1) as follows. ON, ON, OFF, ON Step 4:Power on Pumpkin i350 EVK and login as root. • Push “PWR” button for several seconds. www.thinesolutions.com | © THine Solutions, Inc. All rights reserved | inquiries@thinesolutions.com...
- Page 15 Step 6: Shutdown and power off Pumpkin i350 EVK Step 7: Change the #4 of DIP switch(S1) to “STRM” mode. ON, ON, OFF, OFF Step 8: Power on Pumpkin i350 EVK and login as root. www.thinesolutions.com | © THine Solutions, Inc. All rights reserved | inquiries@thinesolutions.com...
- Page 16 • media-ctl -d /dev/media0 -V "'15040000.seninf':4 [fmt:YUYV8_1X16/4160x3120 field:none]" • gst-launch-1.0 v4l2src device=/dev/video0 ! video/x- raw,format=YUY2,width=4160,height=3120,framerate=20/1 ! queue max-size-time=0 ! waylandsink sync=false fullscreen=true You can see the streaming images on the display. www.thinesolutions.com | © THine Solutions, Inc. All rights reserved | inquiries@thinesolutions.com...
Need help?
Do you have a question about the THEIA-CAM THSCP101 and is the answer not in the manual?
Questions and answers