Panasonic TX-43HX 97 Series Operating Instructions Manual page 21

22 PROVIDER/LIST
Starts operator application or displays channel list.
23 Subtitles
Displays subtitles.
24 Channel Up / Down
25 Last view
Switches to previously viewed channel or input
mode.
26 Operations for contents, connected equipment,
etc.
Installing / Removing batteries
Hook
Close
Note the correct polarity
(+ or -)
Pull open
Remote Control Mode setting
If another Panasonic TV is near the TV, the other TV
may be operated when you use the remote control.
Change the TV's remote control mode to avoid
simultaneous operation.
Remote control mode 1 is the default setting.
1
Display the menu and select [Setup]
Setup
2
Select the remote control setting menu in the [System
Menu]
select
access
3
Select the remote control mode in [Mode Setting]
select
access
4
Select [Mode2]
select
access
Press and hold OK/MUTE/2* (numeric buttons)
buttons for at least 3 seconds, then press the OK
button.
*
To set to [Mode1], set to "1", to set to [Mode3],
set to "3", to set to [Mode4], set to "4".
When using the remote control mode 1, set the TV
and the remote control to mode 1 respectively.
Remote Control Mode Error
When the TV receives a signal with a different remote
control mode to the mode that is set on the TV five
times, Remote Control Mode Error is displayed.
Follow the on-screen instructions.
When all settings are initialised by accessing
Shipping Condition, the TV's remote control mode is
reset to mode 1. If you cannot operate the TV with
your remote control, press and hold OK/MUTE/1
buttons for at least 3 seconds to set remote control
to mode 1.
select
access
21
English