Table of Contents
Advertisement
• Connect the drain hose to the spigot
and tighten it with a clamp.
• Position the hose directly to a built-in
drain pipe in the room wall and tighten
it with a clamp.
• Without the plastic hose guide, to a
sink spigot - put the drain hose in the
spigot and tighten it with a clamp.
• To a stand pipe with vent hole - insert
the drain hose directly into a drain
pipe or stand pipe.
• The drain hose can be bent into U
shape and put around the plastic
guide. On the edge of a sink - fasten
the guide to the water tap or to the
wall.
Make sure that the drain
hose makes a loop to
prevent particles going into
the appliance from the sink.
Make sure that the plastic
guide cannot move when the
appliance drains and the
drain hose end is not
immersed in the water.
There may be a return of
dirty water into the
appliance. Buy accessories
from authorised supplier.
The end of the drain hose
must always be ventilated ,
i.e. the inner diameter of the
drain pipe (min. 38 mm -
min. 1.5") must be larger
than the external diameter of
the drain hose.
5.7 Electrical connection
At the end of installation you can connect
the mains plug to the mains socket.
The rating plate and the 'Technical Data'
chapter indicate the necessary electrical
ratings. Make sure that they are
compatible with the mains power supply.
Check that your domestic electrical
installation can take the maximum load
required, also taking into account any
other appliances in use.
Connect the appliance to an earthed
socket.
The power supply cable must be easily
accessible after installing the appliance.
For any electrical work required to install
this appliance, contact our Authorised
Service Centre.
The manufacturer does not accept any
responsibility for damage or injury
through failure to comply with the above
safety precaution.
ENGLISH
13
Advertisement
Table of Contents
