JVC LT-32WX84/K Service Manual page 40

4.7 ADJUSTMENT PROCEDURE
4.7.1 SETTING BEFORE ADJUSTMENT
(1) Check the following settings before adjustment.
Item setting value
S19 128
S21 128
S23 128
(2) Take note of initial values in the following table before adjustment. Then, set the values to adjustment setting values shown in
the following table. After adjustment procedure, return the values to the initial values you have taken note of (except white
balance adjustment).
The values can be set for each input signal (NTSC etc.), but the values are basically the same among the input signals.
Since the values are not adjusted for 525p/750p (because the values change according to the reference adjustment values), you
do not have to take note of the values if unnecessary.
Initial value
Item
NTSC
S13
S15
S17
(3) Unless otherwise specified in the adjustment instructions, preset the following functions with the remote control unit:
Setting item
VIDEO STATUS
BRIGHT / CONTRAST / COLOR / TINT 00
COLOR TEMPERATURE
DIG. NOISE CLEAR
COLOR MANEGMENT
NATURAL CINEMA
TREBLE / BASS / BALANCE
BBE
A.H.S
A.H.B
ASPECT
NOTE:
Follow the order instructed in adjustment procedure.
1-40 (No.YA090)
contents
R CUT OFF
G CUT OFF
B CUT OFF
Initial value Initial value
525p 1125i
Settings
STANDARD
LOW
OFF
STANDARD
OFF
00
OFF
OFF
OFF
FULL
Initial value
setting value
750p
255
255
255
contents
R DRIVE
G DRIVE
B DRIVE