Summary of Contents for R2 Starcraft Solo P Series
- Page 1 Assembly Instructions Model SS-EXT6P Starcraft Solo 6” Extension Tables P-Series R Squared Specialties, LLC 27708 Tomball Parkway Suite #211, Tomball, TX 77375 713.588.5046 info@rsquaredspecialties.com www.rsquaredspecialties.com Rev. 0 - 2023...
- Page 2 General: 1. Should you need assistance simply give us a call M-F at 713-588-5046 from 8 am - 4 pm Central. You may also email us: info@rsquaredspecialties.com. 2. This kit comes with front & rear table mounting brackets, two six inch extension tables, and hardware to attach tables to brackets.
- Page 3 STEP 2. Attach Right Rear Bracket to Machine. Note: The rear screws can be difficult to remove as you can only get your finger tips on the screwdriver. Take care to keep constant pressure against the screw to avoid stripping the head. A ratcheting screwdriver bit or an offset screwdriver can make removal of these easier.
- Page 4 STEP 3. Attach Left Rear Bracket to Machine. Note: The rear screws can be difficult to remove as you can only get your finger tips on the screwdriver. Take care to keep constant pressure against the screw to avoid stripping the head. A ratcheting screwdriver bit or an offset screwdriver can make removal of these easier.
- Page 5 STEP 4. Attach Rear Table. 1. Install support rods into the bracket notches. Get one of the tables and proceed to next step. 2. Remove the masking film from both sides of the table. Raise the pinch wheel lever and place table on the brackets lining up the mounting holes. Warning label is top side.
- Page 6 STEP 5. Attach Left Front Bracket to Machine. 1. Remove the forward most housing screw from the side of machine. Left Front 2. Install the LF bracket to the machine using the screw removed from previous step. The machine housing covers are plastic and the screw thread can easily strip. Tighten screws just snug, DO NOT OVERTIGHTEN.
- Page 7 STEP 6. Attach Right Front Bracket to Machine. 1. Remove the forward most housing screw from the side of machine. 2. Install the RF bracket to the machine using the screw removed from previous step. The machine housing covers are plastic and the screw thread can easily strip. Tighten screws just snug, DO NOT OVERTIGHTEN.
- Page 8 STEP 7. Attach Front Table. 1. Install support rods into the bracket notches. Get one of the tables and proceed to next step. 2. Remove the masking film from both sides of the table. Place table on the brackets lining up the mounting holes. Warning label is top side. 3.
- Page 9 That’s it, Congratulations! Enjoy using your Starcraft Solo with extended mat support. The extension tables will work for desktop use or mounted on a stand. If using on a stand and wanting to feed from roller and/or use a catch bin the tables can be removed by removing the four screws, leave brackets in place.