Advertisement
Advertisement
Table of Contents
Related Manuals for Mini Jumbotron MACROTRON 32
Summary of Contents for Mini Jumbotron MACROTRON 32
- Page 1 THE MACROTRON 32 - INSTALLATION INSTRUCTIONS © The Mini Jumbotron Company, LLC...
- Page 2 THE MINI JUMBOTRON IS CEILING MOUNTED. DURING ALL STEPS, PLEASE PROTECT THE MINI JUMBOTRON SO IT DOES NOT SCRATCH. Before enjoying your Mini Jumbotron, you will need to assemble its guts. No guts, no glory. Here is the play-by-play: STEP 1: Find a sturdy table close to an electrical outlet for testing. Please protect the base of the Mini Jumbotron and place it on the table.
- Page 3 NOTE: Various sized TV screws & other hardware may be included. Not all hardware included may be used. STEP 4: Attach each Pole Bracket (C) to each Dual Arm Assembly (A) using three ¾” bolts and nuts. © The Mini Jumbotron Company, LLC...
- Page 4 Once you find the correct screws, attach the VESA Plate (B) to the back of each TV using 4 washers, 4 screws and the screwdriver side of the included 6 mm Allen Key (G). © The Mini Jumbotron Company, LLC...
- Page 5 Insert the 6 mm Allen Key (G) into the adjusting hole and turn counter-clockwise (+) to increase gas spring tension, suitable for heavier screens. Please take note it may take numerous turns for gas spring tension adjustment. © The Mini Jumbotron Company, LLC...
- Page 6 The top of each TV should be angled 10-15 degrees towards the floor. You will know they’re at the right angle once you add the Mini Jumbotron frame as the frame should rest on top of the 4 TVs. STEP 9: Grab someone to help you with this next step. Lift up the Mini Jumbotron metal frame and place the center silver flange of Mini Jumbotron frame over the top of the pole.
- Page 7 3. Lift the metal Mini Jumbotron frame and raise it onto and push it up the pole as high as you can. Then tighten the flange screws. (You will lower the frame later onto the TVs but for now let’s push it up out of the way).
- Page 8 Re-install the 4 TVs, make sure they rest on the seal of the base and are angled properly. Plug in everything. Now lower the metal Mini Jumbotron frame so it rests on the 4 TVs and tighten the flange screws. Attach the Velcro plexi-glass panels. When you’ve got it looking good and something displaying on the TVs please text a brief video and pics to 623-606-6176.
Need help?
Do you have a question about the MACROTRON 32 and is the answer not in the manual?
Questions and answers