Advertisement
Features and
Functions Guide
To turn hands-free speaker on, press and hold the
Power button until the indicator light turns purple.
T307
Then, release the button.
Portable Bluetooth®
Note: Hands-free speaker may take up to 3 to 4 seconds to turn
Hands-Free Speaker
on.
To turn your hands-free speaker o , press and hold
the Power button until the indicator light turns
purple and then turns o .
IMPORTANT:
To conserve battery power, your hands-free speaker
Be sure to rst follow the
will turn o when not connected to your phone for
more than 30 minutes.
Quick Start Guide
on the reverse side
of this guide
Indicator Light
to complete initial setup
of your T307.
European Union Directives
Conformance Statement
Function
Hereby, Motorola declares that this
Make a voice dial call
product is in compliance with:
• The essential requirements and
other relevant provisions of Directive
End a call
1999/5/EC.
• All other relevant EU Directives.
Receive a call
0168
Product
Reject a call
Approval
Number
Redial last call
The above gives an example of a typical Product
Approval Number.
You can view your product's Declaration of Conformity
(DoC) to Directive 1999/5/EC (to R&TTE Directive) at
www.motorola.com/rtte. To find your DoC, enter the
product Approval Number from your product's label in
Note: Your T307 supports both Handsfree and Headset Pro les.
the "Search" bar on the web site.
Accessing call functions depends upon which pro le your
phone supports. See your phone's user's guide for more
information.
TURNING HANDS-FREE
INSTALLING HANDS-FREE
SPEAKER ON AND OFF
SPEAKER IN YOUR CAR
Follow these steps to install your hands-free
speaker in your car:
1
Slide the visor clip onto the mounting bracket on
the bottom of the hands-free speaker. To do this,
place the loop end rst onto the hands-free
speaker and slide forward as shown below.
Power Button
MAKING CALLS
MAKING CALLS
Action
Function
Tap the Call button
Answer a second
and speak the
incoming call
name after the tone
Tap the Call button
Toggle between two
(if a call is on hold,
active calls
tap twice to end all
Mute or unmute a call
calls)
Tap the Call button
Note: Some features are phone/network dependent.
Tap either Volume
button
Note: When turning on your hands-free speaker during a phone
call, audio is transferred automatically to your hands-free speaker
Press and hold the
(when your hands-free speaker and phone have previously been
Call button until you
connected, and your phone supports this feature).
hear a beep
INSTALLING HANDS-FREE
SPEAKER IN YOUR CAR
Continued
2
Slide the visor clip onto your sun visor.
When installed, the Power button must be facing
toward you as shown.
The visor clip is reversible to allow placement of
your hands-free speaker on either the front or
the back of your car's sun visor.
INDICATOR LIGHTS
CONTINUED
With the Charger Plugged In
Indicator Light
Action
Press and hold the
Note: Charging status not displayed when hands-free
Call button (places
speaker is in use.
rst call on hold)
Steady red
Press and hold
Steady blue
the Call button
With No Charger Plugged In
Tap both Volume
buttons
Indicator Light
O
Steady purple
Steady blue
Quick red ash
Blue with quick
purple ashes
Slow blue pulse
Blue ash
Standby (not on call)
Quick blue ash
Slow purple pulse
ADJUSTING HANDS-FREE
SPEAKER VOLUME
You can adjust hands-free speaker volume using
the Volume buttons. To adjust volume, tap or
press and hold button.
Volume
Down (-)
Button
Note: Hands-free speaker volume cannot be adjusted during
an incoming call.
AUDIO TONES
The audio tones provide information about your
hands-free speaker status.
Status
Audio Tone
Single high tone when
Charging
pressing Volume button
Charging complete
Five rapid high tones
repeated every 60 sec.
No audio indications;
deteriorating quality
Status
Power o
Ring tone
Incoming call
Powering up
Single high tone
Pairing mode
Single low tone
Battery low
Dual high/low tone Voice tag not
(phone dependent)
Pairing successful
Single high tone
Low to high tone
Connected (on a call)
Two ascending tones
Incoming call
Two descending tones
Muted
Volume
Up (+)
Button
Status
Volume at minimum
or maximum
Low battery
Out of range
Pairing con rmation
Voice activation
recognized
End call
Phone network
not available
Mute enabled
Mute disabled
Advertisement
