Advertisement
Table of Contents
STAND IS DESIGNED TO HOLD A VARIETY OF STYLES OF HANGING
CHAIRS, HAMMOCK CHAIRS, AND WICKER HANGING CHAIRS.
THIS IS A STAND ONLY – CHAIR IS NOT INCLUDED
WHEN ASSEMBLING THIS STAND, TIGHTEN BOLTS LOOSELY DURING
ASSEMBLY SO THAT HOLES CAN BE EASILY ALIGNED. ONCE FULLY
ASSEMBLED GO BACK AND FULLY TIGHTEN EACH PIECE SO STAND IS
SECURE.
Warning:
• The recommended weight capacity of this stand is 250 lbs.
Never exceed the weight capacity of the stand or the chair
being hung from the stand.
• Never use the chair or stand as a swing as swinging could
cause the frame to tip over causing injury.
• Only one person should use the chair on stand at a time.
• Children should never use the chair or stand without close
adult supervision.
• Always inspect stand before each use to assure all pieces are
fully tightened, and stand and chair being used are secure.
• The stand must always be used on a flat surface to avoid
tipping which could cause injury.
Hammock Chair Stand
SKU 273-8597
Advertisement
Table of Contents
Summary of Contents for Backyard Creations 273-8597
- Page 1 SKU 273-8597 Hammock Chair Stand STAND IS DESIGNED TO HOLD A VARIETY OF STYLES OF HANGING CHAIRS, HAMMOCK CHAIRS, AND WICKER HANGING CHAIRS. THIS IS A STAND ONLY – CHAIR IS NOT INCLUDED WHEN ASSEMBLING THIS STAND, TIGHTEN BOLTS LOOSELY DURING ASSEMBLY SO THAT HOLES CAN BE EASILY ALIGNED.
- Page 2 Parts List Part A (A1 & A2) Upper Upright Part B, (X 2) Lower Upright Part C, (X 2) Back Legs Part D, (X 2) Front Legs Part E, Center X-Brace Part F, Hanging Chain Part G, Locking Carabiner Part H, (x 11) Screw Knobs Part I, Wing Nut Part J, Locking C-Hook Part K, (x 4) Ground Stakes...
- Page 3 Instructions: Diagram 2 Diagram 1 Diagram 3 Begin assembly by locating center X-brace (Part E), and 2 front legs(Part D) along with 2 back legs(Part C). Insert all 4 legs into X-brace as shown in diagram 1. Align holes in legs with holes in X-brace and attach using screw knobs as shown in diagram 2, to complete the base as shown in diagram 3 Diagram 4 Diagram 5...
- Page 4 Diagram 9 Diagram 8 Diagram 7 Locate the 2 upper uprights (Parts A1 & A2). Place the narrow end of each upper upright into the lower upright, align holes, and use a screw knob (Part H) to secure as in diagram 7. Repeat on opposite side. Next, align the holes on the flat plate of the upper uprights.
- Page 5 CAUTION! ALWAYS USE STAND ON A LEVEL SURFACE. DO NOT SWING, BOUNCE OR JUMP WHEN USING THIS PRODUCT. SERIOUS INJURY CAN RESULT FROM IMPROPER USE. The hanging chair stand and your chair have a maximum weight capacity of 250 lbs. Never exceed maximum weight capacity of the stand, or hanging chair being used.
Need help?
Do you have a question about the 273-8597 and is the answer not in the manual?
Questions and answers