Larson Electronics EPL-16C-1MLED Instruction Manual

21,000 Lumens LED - Wheelbarrow Cart - 150' Cord
Thank you for your purchase of the Larson Electronics EPL-16C-1MLED Explosion Proof LED Tank Light.
WARNING
TO AVOID THE RISK OF FIRE, EXPLOSION OR ELECTRIC SHOCK, THIS PRODUCT SHOULD BE INSTALLED,
INSPECTED AND MAINTAINED BY A QUALIFIED ELECTRICIAN ONLY, IN ACCORDANCE WITH ALL
APPLICABLE ELECTRICAL CODES.
TO AVOID ELECTRIC SHOCK:
•
BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.
•
PRODUCT MUST BE CONNECTED TO A WIRING SYSTEM WITH AN EQUIPMENT-GROUNDING
CONDUCTOR.
TO AVOID EXPLOSION:
•
MAKE SURE THE SUPPLY VOLTAGE IS WITHIN THE VOLTAGE RATING.
•
ENSURE THE MARKED T RATING IS LESS THAN THE IGNITION TEMPERATURE OF THE HAZARDOUS
ATMOSPHERE.
•
DO NOT OPERATE IN AMBIENT TEMPERATURES ABOVE THOSE INDICATED ON THE PRODUCT
NAMEPLATE.
•
DO NOT OPERATE IF THE LENS, CORD, SEALS, HOUSING, RECEPTACLES, ETC. IS CRACKED OR
DAMAGED. IF SO, DISCONTINUE USE AND CONTACT MANUFACTURER FOR REPLACEMENT PARTS.
•
ALL FASTENERS SHOULD BE PROPERLY SEATED.
The EPL-16C-1MLED Explosion Proof Portable Tank Light from Larson Electronics is rated Class 1 Division 1-2 Groups
C&D and Class II Division 1-2 and uses Cree LEDs to produce 21,000 lumens of light while drawing only 150 watts.
The light fixture on this wheelbarrow cart is factory sealed.
CART OPERATION
The wheelbarrow cart assembly consists of 2 parts:
1. Light head
2. Wheelbarrow cart base
 To assemble cart, insert light head over center hole
of wheelbarrow cart and tighten hand screw. The
wheelbarrow cart is now ready for use.
 Tilt cart using both handles and maneuver like a
wheelbarrow. Simply roll entire assembly to a new
location once assembled. Make sure light head is
secure prior to maneuvering cart.
 This portable LED cart light has a removable light
head measuring 16 inches in diameter which allows
the unit to fit through the standard sized manholes or
entry passages commonly found in the petrochemical and marine industries. Often simply referred to as a
"tank light", this unit is considered universal due to its ability to be passed through any conventional manhole
such as those found in petrochemical containers and ship storage tanks.
WARNING: Be sure all hand screws are tight before transporting! Use caution when maneuvering near inclines
or drop offs.
To adjust light head vertically, loosen hand screws on either side. Once desired angle is achieved,

tighten both hand screws to secure light in its place. Loosen the single hand screw holding light head to rotate
horizontally. Be sure all hand screws are tight before transporting!
Larson Electronics, LLC
Explosion Proof LED Tank Light
Instruction Manual
Phone: (877) 348-9680 Fax: (903) 498-3364
EPL-16C-1MLED
www.larsonelectronics.com 1 of 2