Fatar ST-490 Plus User Manual

Studio series keyboard controllers

Welcome to the world of the Fatar Studio Series Keyboard Controllers.

Congratulations on purchasing the ST-490 Plus, one of the finest master keyboard

controllers in the world today. The Studio-490 Plus is the perfect choice for a

musician looking for a simple yet versatile keyboard controller to produce quality

results for the live or studio environment.

TECHNICAL CHARACTERISTICS:

* 49 keys

* One zone

* Velocity Sensitive

* Two Parallel MIDI Outputs

* Sustain Input Jack

*Volume Input Jack

* Program change, MIDI Channel, Transpose.

* External Adapter 9V DC 500mA included

1) Connect the AC adapter cable to the power input jack, in the back of the

controller, located next to the power switch. See Figure #1.

Make sure that the AC adapter corresponds to the correct voltage output. The

Studio 490 Plus will accept an adapter that has a rating of 9V DC with a positive

polarity tip and has a minimum current of 200 ma.

Figure #1.

Table of Contents

Do you have a question about the ST-490 Plus and is the answer not in the manual?

Page 1 Welcome to the world of the Fatar Studio Series Keyboard Controllers. Congratulations on purchasing the ST-490 Plus, one of the finest master keyboard controllers in the world today. The Studio-490 Plus is the perfect choice for a musician looking for a simple yet versatile keyboard controller to produce quality results for the live or studio environment.
Page 2: Program Change
6lOPlus. Each channel would normally be assigned to a different sound or effect. Since the ST-490 Plus has only one zone, you can only program one of thel6 channels at a time. Make sure that your sound source is properly assigned to the channel you are sending on.
Page 3 C. The result will be a new key change when the C major keys are played. Your range is limited to 24 half steps up and 24 half steps down. If there are any technical problems that relate to the ST-490 Plus only, please contact Music Industries Corp. 800-431-6699. Best of luck!"...
Page 4 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause interference to radio communications.

Studio 490 plus