Videx CyberLock ValidiKey 2 Vault Mounting Manual

ValidiKey 2 Vault
1) Connect power to the ValidiKey 2 vault and open the tray door.
Do not allow the door to close. Disconnect power and any other
cabling to the vault.
2) Unscrew the two screws next to the key bezels in the key tray
shown in Figure 1 and set them aside.
3) Gently pry the corner tabs up with a flat-bladed screw driver as in
Figure 2. Slide the front assembly (Figure 3) of the vault up and
out from the mounting box (Figure 4).
4) The accompanying mounting template can be used to mark the
positioning of the cable access cutout and the screw holes. The
tray door will need at least 1.25 inches (3.175 cm) of clearance to
open. The ValidiKey 2 vault is designed to be mounted on a single
or double gang electrical box with #6 screws. Use two screws
for a single gang box and four screws for a double gang box. M3
screws can be used if they are compatible with the electrical box.
5) Mount and secure the mounting box.
6) Feed cabling through the cutout and connect to the front
assembly.
7) Seat the front assembly back into the mounting box until the
corner tabs snap into place. Do not allow the door to close.
Warning: Make sure the vault has power and works
properly before installing further!
8) Re-secure the front assembly with the key tray screws.
For any additional assistance, please contact your reseller or
CyberLock Technical Support by phone at (541) 738-5500 or by
emailing support@cyberlock.com
Figure 3: Front Assembly
MN-CKV-25
Mounting Guide
CyberLock
by Videx
Key Tray Screws
Figure 1: Key Tray Screws
Figure 2: Pry corner tabs to loosen
Cable Access
Figure 4: Mounting Box
®
Cutout
GCO 3799