Gigabyte B365M GAMING HD User Manual page 40

A-2: Installation in Intel RST Premium With Intel Optane System Acceleration mode
If the SATA controller has been configured in Intel RST Premium With Intel Optane System Acceleration mode,
please follow the steps below:
1. After system restarts, go to the BIOS Setup, make sure CSM Support under the BIOS menu is disabled.
2. Go to Peripherals\SATA And RST Configuration and make sure Use RST Legacy OROM is disabled. If
you want to enable the Optane
9 to RST Controlled.
3. Enter the operating system, launch the Intel
enable Intel Optane Memory on the Intel
® ™
4. Then select which drive to be accelerated. Click Yes to continue. Follow the on-screen instructions to proceed.
When completed, restart the system.
5. Launch the Intel Rapid Storage Technology utility from the Start menu and make sure the Intel
®
Memory has been enabled. If you want to accelerate the system drive, you can select specific folders, files, or
applications to accelerate using the Intel
used must have at least 32 GB capacity.)
• An Optane memory cannot be used to accelerate an M.2 PCIe SSD.
™
• Do not abruptly remove the Optane
functioning correctly.
• If you want to change/remove the Optane
Storage Technology or Intel(R) Optane
• After enabling the Optane
memory installed in the M2M connector, set PCIe Storage Dev On Port
™
Rapid Storage Technology utility from the Start menu, and then
®
Optane Memory screen.
® ™
Optane Memory Pinning function. (The Intel
® ™
memory. Doing so will cause the operating system to stop
™
memory, you must disable it using the Intel
™
Memory application first.
™
memory, the related BIOS settings will remain even after a BIOS update.
™
- 40 -
Optane
® ™
Optane memory
® ™
Rapid
®