Table of Contents
Advertisement
G90TR
Dual Function Touch Monitor
1. Connect AC/DC Power Cable to Adaptor and then connect
Adaptor Cable to Monitor through the jack "12V DC" .
2. One end of "Audio Cable" to PC through the jack, "Audio Out".
And the other end to Monitor " Audio In".
3. Connect PC and Monitor through the jack, D-Sub (Analog signal) with D-Sub cable
4. Connect PC and Monitor through the jack , DVI (Digital signal) with DVI Cable.
5.
Insert the other 15-pin signal cable connector into the 15-pin VGA connection
on your computer and screw it down.
6.
Plug the power cord connection to connection on the monitor.
7.
Plug the other end of the power cord to your computer's main supply or to a
100V-240V earthed electrical outlet.
8.
Turn on the monitor using the power switch and check that the power LED is
on. If not, repeat steps 1,2,3,4,5,6 and 7 or refer to the Troubleshooting section
of this guide.
9.
Turn on the power to the computer. The picture will appear within about 10
seconds. Adjust the picture to obtain optimum picture quality. See section
Adjusting the picture in this guide for more information.
7/24
Advertisement
Table of Contents
