Installing The Wall-Hanging Bracket; Connections - Panasonic MZ2000G Series Operating Instructions Manual

Installing the wall-hanging
bracket
Please contact your local Panasonic dealer to purchase
the recommended wall-hanging bracket.
a
b
a
300
65-inch model
<Warning>
Using other wall-hanging brackets, or installing a wall-
≥
hanging bracket by yourself have the risk of personal
injury and product damage. In order to maintain the
unit's performance and safety, be absolutely sure to
ask your dealer or a licensed contractor to secure the
wall-hanging brackets. Any damage caused by
installing without a qualified installer will void your
warranty.
Carefully read the instructions accompanying optional
≥
accessories, and be absolutely sure to take steps to
prevent the TV from falling off.
Handle the TV carefully during installation since
≥
subjecting it to impact or other forces may cause
product damage.
≥ Take care when fixing wall brackets to the wall.
Always ensure that there are no electrical cables or
pipes in the wall before hanging bracket.
To prevent fall and injury, remove the TV from its fixed
≥
wall position when it is no longer in use.

Connections

Refer to [eHELP] and the separate sheet for details
about connections.
≥ Please ensure that the unit is disconnected from the
mains socket before attaching or disconnecting any
cables.
Keep the TV away from electronic equipment (video
≥
equipment, etc.) or equipment with an infrared sensor,
otherwise distortion of image / sound may occur or
operation of other equipment may be affected.
≥ Please also read the manual of the equipment being
connected.
8
English
c (Minimum)
d (Maximum)
e
b c d
mm
300 12 39
Basic connections
∫ AV devices
(DVD Recorder / Blu-ray Recorder, Set top box, etc.)
For details, refer to [eHELP] (Search by Purpose >
≥
Watching > Basic > Basic connection).
∫ Aerial
(For viewing digital / analogue broadcasts)
Special notices for receiving digital terrestrial
services
If you receive analogue and digital TV signals through
≥
two separate aerials, use an RF mixer to mix them.
TV
e
–
Aerial
M6
RF cable
RF mixer
Aerial (Analogue TV)
Aerial (Digital TV)
If you receive analogue TV signals through a cable TV
≥
network, an aerial is required to receive digital TV
signals.
In this case, using an RF mixer is not recommended
because the TV signals interfere with each other.
An RF selector is available to switch analogue and
≥
digital TV signal.
TV
Aerial
RF cable
RF selector
Aerial (Digital TV)
TV
Aerial
RF cable
Aerial
≥ Keep the space between the TV and RF cable to
prevent distorted image.
Do not put the RF cable close to the mains lead to
≥
avoid noise.
Do not place the RF cable under the TV.
≥
Cable
(Analogue TV)