Marathon MFF100BLS Owner & User Manual page 3


Before connecting the appliance to the power supply, let it stand for about 4 hours, which will reduce a possibility of
malfunctions in the cooling system due to transport handling.

Clean the appliance, and be thorough, especially in the interior (See "HOW TO CLEAN").

In case the interior accessories are not correctly placed, rearrange them as described in "Parts Description"

Install the appliance in a convenient location away from extreme heat and cold. Allow sufficient clearance between the
fridge and side wall so the door will open without obstruction. The freezer is not designed for built in installation.

Select a space with strong level floor.

Try to allow a minimum of 5 inches of space between the appliance's side and the wall.
DANGER: Risk of child entrapment. Before you throw away your old appliance:
Remove the doors and/or lid.
Leave the shelves in place so that children may not easily climb inside.

The appliance must be correctly connected to the power supply, DO NOT use an extension cord.
 Do not touch COLD or FROSTY surfaces while the appliance operates, especially with wet hands as the skin may
stick to the cold surface.
 Disconnect the appliance from the power supply before repair or maintenance
 Do not defrost the appliance with other electric devices (hair dryer etc.) and never scrape the ice or frost layer with
sharp tools.
 The rating plate is on the back of the appliance.
Tips for Energy Savings

Try not to open the door too often, especially when the weather is wet and hot. Once you open the door, mind to close it as soon as possible.

Every now and then check if the appliance is sufficiently ventilated (adequate air circulation around the appliance).

Ice and frost layer increase energy consumption, so please defrost the appliance as soon as the accumulated ice/frost layer is 1/8" thick.
Replacing the Light Bulb
1. Switch off the refrigerator and pull out power cord from wall socket. Wait several minutes until the bulb is cool to the touch..
2. Remove the bulb cover by removing a screw that holds the cover.
3. Unscrew the old bulb and replace a new bulb (Max. 10W)
4. Reinstall the bulb cover and fix it by the screw previously removed.
5. Plug the refrigerator back in to the electrical outlet.
Cleaning Your Refrigerator
Cleaners: Never use harsh, abrasive cleaners, heavy-duty cleaners, or solvents on any surface.
Exterior: Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains and for periodic waxing, use silicon wax.
Interior: Wash shelves and other removable parts in warm sudsy water, rinse and dry. Wash interior with baking soda solution (3 tablespoons to I liter of
water) or warm sudsy water, rinse and dry.
Installation Instructions
Important
2
MFF100W & MFF100BLS