Do you have a question about the SMT-D and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for Sentera SMT-D
Page 1
SMT-D CONTROL SWITCH Mounting and operating instructions...
Page 2
SMT-D CONTROL SWITCH Table of contents SAFETY AND PRECAUTIONS PRODUCT DESCRIPTION ARTICLE CODES INTENDED AREA OF USE TECHNICAL DATA STANDARDS WIRING AND CONNECTIONS MOUNTING INSTRUCTIONS IN STEPS TRANSPORT AND STORAGE WARRANTY AND RESTRICTIONS MAINTENANCE MIW-SMTD-AL-EN-000 - 31 / 10 / 2019 2 - 7 www.sentera.eu...
Page 3
SMT-D CONTROL SWITCH SAFETY AND PRECAUTIONS Read all the information, the datasheet, mounting and operating instructions and study the wiring and connection diagram before working with the product. For personal and equipment safety, and for optimum product performance, make sure you entirely understand the contents before installing, using, or maintaining this product.
Page 4
SWITCH PRODUCT DESCRIPTION The SMT-D control switch uses 10 VDC supply voltage and converts it into different step voltages to obtain a minimum, medium and maximum. Two of the output voltages can be adjusted according to the environmental requirements (switch positions 1 and 2).
Page 5
Connections Cable cross section: max. 2,5 mm MOUNTING INSTRUCTIONS IN STEPS Before you start mounting the SMT-D switch, read carefully “Safety and Precautions”. Then proceed with the following steps: For inset mounting Remove the knob by turning it to the right, beyond the stop end and then pull.
Page 6
SMT-D CONTROL SWITCH Fig. 2 Mounting dimensions - inset mounting For surface mounting Mount the external enclosure to the wall with the help of the delivered dowels and screws. Mind the unit mounting dimensions (see Fig. 3 Mounting dimensions - surface mounting).
Page 7
SMT-D CONTROL SWITCH TRANSPORT AND STORAGE Avoid shocks and extreme conditions; stock in original packing. WARRANTY AND RESTRICTIONS Two years from the delivery date against defects in manufacturing. Any modifications or alterations to the product after the date of publication relieve the manufacturer of any responsibilities.
Need help?
Do you have a question about the SMT-D and is the answer not in the manual?
Questions and answers