Advertisement
Assembly Instructions for Pro
Assembly Instructions for
Assembly Instructions for Pro
This instruction sheet was designed to help you assemble this unit in the proper way, please follow them using all
parts and fasteners provided. Any alteration or deviation from this instruction sheet can result in unit failure. If
you have any assembly problems or questions, please feel free to contact our Pro-Maxx manufacturing facility at
(773) 475-3000 during the hours of 9:00 a.m. to 5:00 p.m. central standard time and ask for customer service.
We have people available to assist you if need be with any part of this assembly process.
IT IS HIGHLY RECOMMENDED TO ASSEMBLE THIS UNIT AT EYE LEVEL, AND WITH THE HELP OF AN
ADDITIONAL PERSON. Using a RAISED surface such as a TABLE or DESK, will greatly EASE the ASSEMBLY
PROCESS. Assembly attempted on a much lower surface such as the floor, is still possible but does make the
assembly process longer and harder. During the shipping and handling of this product, some of the panels may
have a MINOR bend such as on a corner, door hinge pin, or a tab. This minor variation can be REPAIRED SIM-
PLY by using a SMALL TOOL or your HAND to move the material back to its designed form. A example will be
outlined in the "GETTING STARTED" section listed below. Some of the materials used in the packaging to pro-
tect the parts from damage may leave dust or smudges on the steel panels. It is RECOMMENDED AFTER AS-
SEMBLY IS COMPLETE to use a MILD SOAP and WATER with a SOFT CLOTH to wipe the unit clean.
Getting Started
Getting Started
Getting Started
This assembly process uses tabs, screws, and nuts to hold the parts together. To speed the assembly
process, have a 3/8" nut driver or socket, and a small tipped screwdriver ready. Also have your pack-
aged hardware at close reach. After unpacking all the panels, visually inspect the corners. These are
the most susceptible to damage through the shipping and handling process. If you find a corner bent
out of place, use your hand and gently move the corner back to the designed shape. Also during ship-
ping and handling some of the tabs used for engaging the panels together may have become closed.
Visually inspect all panels and if found that some are closed, use a small tipped screwdriver to push the
tabs from behind to open slightly. A example of pushing the tabs out and how the engagement process
works, is shown below.
Push tab slightly
from back side
to open
Small tipped
screwdriver
Step 1 - Back Assembly
Place the left and right hand backs on a level surface.
Position the parts so that all the tabs are facing up.
Place the part with the rectangular holes (left hand back)
over the part with the tabs (right hand back). Making
sure the tabs ride into the rectangular holes, slide the
backs together. Check to make certain that all the tabs
and rectangular holes have engaged completely and that
the screw holes on the back panels have properly
aligned (see figure 1 for references). Use your small
tipped screwdriver to assist in aligning the screw holes if
necessary.
Maxx Cabinets
Pro-
-
-
Maxx Cabinets
Maxx Cabinets
Important Please Read First
Important Please Read First
Important Please Read First
Piece with tab
goes under piece
with rectangular
hole
Slide part
Slide part
Figure 1– Back Assembly
Page 2
Page 2
Page 2
Tab fully engaged
Advertisement
