Table of Contents
Advertisement
ATTENTION!
If residual water in the appliance
freezes, this may cause damage to
the appliance.
Do not install or operate this appli-
▶
ance anywhere that is liable to ex-
perience frost or outdoors.
If the appliance is tilted at an angle
greater than 40°, residual water may
leak out of the appliance and cause
material damage.
Tilt the appliance carefully.
▶
Transport the appliance in an up-
▶
right position.
Installation loca-
tion
Base
Wooden joist
floor
Requirements
Secure the appli-
ance with fixing
brackets
→ Page 31.
Place the appli-
ance on a water-
resistant wooden
board (minimum
thickness of
30 mm) which is
screwed tightly to
the floor.
Installation and connection en
Installation loca-
tion
Kitchen unit
Against a wall
4.4 Removing the transit
bolts
The appliance is secured for trans-
portation using transit bolts on the
rear of the appliance.
Note: Keep the transit bolt screws
and the sleeves in a safe place for fu-
ture transport → Page 51.
Requirements
Only install the
appliance under-
neath a continu-
ous worktop that
is securely con-
nected to adja-
cent cabinets.
Required niche
width: 60 cm.
Note: The use of
sliding plates
→ "Accessories",
Page 31 makes
it easier to slide
the appliance
into the recess.
Moisten the slid-
ing plates with a
mixture of water
and washing-up
liquid before
pushing the ap-
pliance in. Do
not use grease
or oil to do this.
Do not trap the
hoses between
the wall and the
appliance.
13
Advertisement
Table of Contents
