1. Introduction 1.1 Read this operation manual carefully ELIET machines are designed for safe and reliable use if they are operated in accordance with the instructions provided. Carefully read these operating instructions before using the machine. Failure to do so may result in personal injury or damage to the equipment.
Welcome to the family of ELIET users. We thank you for the trust that you have placed in ELIET and we are convinced that you have purchased the very best machine. The operating life of your ELIET machine depends on how you care for your machine.
5. Operator safety symbols ELIET cannot anticipate every situation in which a risk or danger can occur. The warning symbols in this operating manual and the labels on the machine are therefore not comprehensive. Al- though minimal, a residual risk will always be present. If while operating the machine you apply a working method, operation or technique that is not explicitly recommended by ELIET, make sure that it does not represent a danger for bystanders.
6. Main machine parts To fully understand the content of this operating manual you need to be fully conversant with the terminology used for the descriptions. This chapter refers to a broad range of machine parts and identifies their names. We recommend that you take the time to study the machine prior to its use for a better understanding of the descriptions provided in this operating manual.
Your ELIET dealer remains at your service for any maintenance or advice, en- suring your ELIET machine is always in perfect condition. You can contact him for original ELIET parts and lubricants at any time. These service parts are ma- nufactured according to the same strict rules and craftsmanship as the original equipment.
7. Safety instructions 7.1 Safety messages Safety stickers or relief images have been affixed on to visible areas of the machine. Make a note of the icons and warnings specified on these stickers. This sticker is affixed near the exhaust and warns the operator of hot surfaces with a high risk of burns.
Page 11
Item no.: BQ 505 010 040 Caution: Safety stickers or parts that include safety information that are damaged due to use or cleaning, have become illegible or have been removed must be replaced immediately. Stickers and parts can be obtained from any authorised ELIET dealer.
7.2 Safety features Warning: Never attempt to circumvent or disengage safety devices. Safety measures were designed for your safety. Before using the machine, the operator should check that the safety device works properly. Any defects must be repaired prior to using the machine. Dead-man’s handle: This handle is mounted on the han- dlebar and must be pressed in order to start the engine.
• If the instructions stated in this manual are not clear to you, do not hesitate to contact your Eliet dealer for further explanation. In addition, the ELIET help desk is at your service during office hours to answer any questions you may have (EU +32 56 77 70 88).
• Children and animals should be kept at a safe distance (10 m) from the machine. • ELIET advises against lending the machine to others, but if this should occur, it should only be lent to persons who are familiar it. Always make sure that the user is aware of the potential hazards and ensure that he/she reads the manual before using the machine.
(such as shouting, signal sounds) will on ly be heard to a limited de- gree. • ELIET does not recommend using a Walkman or a portable MP3 layer whilst working. • Always make sure the engine is switched off and the spark plug removed before performing...
8.1 Unpacking the machine • ELIET machines are packaged in accordance with common rules for proper transportation. Deliveries are always ex factory. Consequently, ELIET cannot be held liable for any damage occurred during transport. • If the packaging is damaged upon receipt of the goods, check the state of the machine to ensure it is not damaged.
• The dealer makes a final test drive and checks that all devices are working properly. • The dealer checks that all safety features are working perfectly. • Every ELIET dealer warrants a long life span of ELIET machines. He will lubricate the hinges before delivering the machine to the client.
Page 18
Caution: Finally the dealer ensures the guarantee card is completed and signed in order to avoid disputes in any warranty cases. Please refer to the guarantee condi- tions for further information.(“15. Warranty Conditions” op pagina 37)
9. Operating instructions 9.1 Preliminary checks Caution: Try making a habit of checking the following points before getting to work with the machine: Checklist • Check the machine’s hours of operation and compare this figure to the maintenance table. (read “11.2 Maintenance schedules” on page 28). •...
• Always allow the engine to cool off for a few minutes before topping up with fuel. • Only use fresh petrol. • For environmental reasons, ELIET recommends the use of unleaded petrol. Additives may be added in order to extend the freshness life.
9.4 Starting the engine Caution: Never start the machine if there is dust or dirt on the engine or between the cooling fins of the engine This prevents optimal cooling of the engine and more importantly can cause fire. For your information: The procedure to start the engine can vary per brand.
9.5 Working with the machine Warning: For optimum protection of your hearing, please put on the supplied hearing protection prior to starting the engine. 9.5.1 Prior to starting work Pay attention to the following safety instructions before starting to operate the machine. •...
• The air velocity can be controlled by adjusting the engine re- gime. This is done by decreasing throttle. • In case of an emergency, simply release the dead-man’s handle: this will cut off the engine. For your information: If removing leaves, one should obviously not work against the wind, otherwise the leaves that are blown free by the artificial air stream will be placed back onto the previously cleaned work area by the natural wind.
9.7 After finishing the work 9.7.1 Cleaning the machine ELIET recommend cleaning the machine after each use. We recommend using every cleaning event to perform an inspection where you check component and machine integrity. You can, thus, intervene on time to prevent faults and failures. This will ensure that the service life of your machine is improved.
Page 25
Allow the engine to cool down properly before treating it with water. Any necessary replacement and/or repair works must be undertaken immediately. Ask your authorised ELIET dealer to carry out repairs (find an authorised ELIET dealer near you on www. eliet.eu).
10. Transporting the machine • When transporting the machine, always take care to turn off the motor. • Do only allow responsible adults move or transport the machine. • During transport, children, unauthorised people or animals must not be allowed within a 3 m radius of the machine.
11. Maintenance 11.1 General ELIET recommend that the machine should be brought to an official ELIET dealer for a major overhaul each year. (Find an authorized ELIET dealer near you by visiting www.eliet.eu.) Your ELIET dealer is always at your service for maintenance and advice. Your dealer will stock genuine ELIET service parts and lubricants.
11.2 Maintenance schedules A. Routine checks before each job. • Visual inspection of machine condition • Checking oil level in engine • Cleaning the air filter • Checking and tightening the bolts of the impeller. • Machine cleaning • Checking the tyre pressure.. B.
• Pull the oil level dipstick out of the oil filler opening. • Usually, the oil level cannot be correctly read immediately. Wipe the dipstick clean, place it back in the oil filler opening, but do not tighten it. • Pull the dipstick out again, and read the correct oil level. •...
Page 30
• If any deformities or ruptures are discovered on the impeller, repairs must be carried out immediately. • In order to dismantle the impeller, the front plate of the blower must be detached in full. To do this, the blower nozzle must be detached also.
• Refit and tighten the plug into the drain. Use a clean cloth to wipe away any spilt oil. • Refill the engine with new four-stroke oil. For this purpose ELIET recommends a top quality oil with a high detergent content : SUNOCO DENALUBE SAE 20W50 API SF / CC.
This action is completely identical to cleaning the air filter (see “11.4.3 Cleaning the air filter” on page 29). • A new air filter of the correct type is available from your ELIET dealer or from a service centre approved for this type of engine.
Page 33
• A grease nipple has been provided for lubricating the hinge of the swivel caster. • Place a grease pump on the grease nipple and pump the grease into the bearing casing. • ELIET recommends high quality lubricants from SUNOCO. (Sunoco Multipurpose LR-EP 2) • All lubricants indicated are available from your ELIET dealer.
• Always allow the machine to cool down before storage. • If the machine is stored outdoors, it must be properly covered with canvas. Avoid precipitation coming in direct contact with the machine. ELIET highly recommends a sheltered storage place.
EN 15503: “Garden equipment - Garden blowers, vacuums and blower/vacuums - Safety” ELIET mfg. cy. hereby declares that after performing a hazard analysis, it is fully aware of the potential hazards and risks associated with the machine. In this knowledge, the necessary steps have been taken in line with Machine Directive 2006/42/EC in order to ensure absolute operator safety for the operator, when the machine is used correctly.
• If it turns out that the defect was caused by acting against the instructions or advice of the user manual in. • When the defect occurs after a repair by an unofficial ELIET dealer or a repair using parts that are not original ELIET parts.
Page 38
• Step 4: The dealer then orders the parts needed to perform the repairs. Next, the dealer faxes the order form together with the completed warranty form. • Step 5: The warranty form should be stapled to the purchase invoice and mailed to ELIET or an importer/agent of ELIET.
Need help?
Do you have a question about the BL360 and is the answer not in the manual?
Questions and answers