Advertisement
Quick Links
ECONO FLO VSA 165 VARIABLE SPEED PUMP
READ AND FOLLOW ALL INSTRUCTIONS • SAVE THESE INSTRUCTIONS
WARNING: Before installing this product, read and follow all warning notices and instructions accompanying this
pump. Failure to follow safety warnings and instructions can result in severe injury, death, or property damage.
ATTENTION INSTALLER: This manual contains important information about the installation, operation, and safe
use of this product. This information should be given to the owner/operator of this equipment.
NOTE: When pump is mounted permanently within 5 ft. of the inside walls of a swimming pool, you must use
No. 8 AWG or larger conductor to connect to bonding conductor lug.
WARNING: To reduce the risk of injury, do not permit children to use this product unless they are closely
supervised at all times.
CAUTION: For hot tubs and spas, do not install within an outer enclosure or beneath the skirt of a hot tub or spa
unless so marked.
Designed,
Engineered &
Manufactured
in the USA
OWNER'S MANUAL
IMPORTANT SAFETY INSTRUCTIONS
www.firstchoicepool.com - customerservice@firstchoicepool.com
Ontario, Ca. 91761
810-1165.0413
Advertisement
Summary of Contents for First Choice ECONO FLO VSA 165
- Page 1 ECONO FLO VSA 165 VARIABLE SPEED PUMP OWNER’S MANUAL IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS • SAVE THESE INSTRUCTIONS WARNING: Before installing this product, read and follow all warning notices and instructions accompanying this pump. Failure to follow safety warnings and instructions can result in severe injury, death, or property damage.
- Page 2 WIRING WARNING: RISK OF ELECTRICAL SHOCK OR ELECTROCUTION. This pool pump must be installed by a licensed or certified electrician or a qualified pool serviceman in accordance with the National Electrical Code and all applicable local codes and ordinances. Improper installation will create an electrical hazard which could result in death or damage to property.
- Page 3 Please store this instruction sheet and the A.O. Smith user interface booklet in a safe place for future use. Please carefully read the entire enclosed booklet for the operation and troubleshooting of the Econo Flo VSA 165. For technical assistance or questions related to the operation of the A.O.
-
Page 4: Pump Strainer Basket
PUMP STRAINER BASKET This unit, sometimes referred to as the “Hair and Lint Pot”, is the unit in front of the volute. Inside the chamber is the basket which must be kept clean of leaves and debris at all times. View basket through the “See Through Lid” to inspect for leaves and debris. Regardless of the length of time between filter cleaning, it is most important to visually inspect the hair and lint pot basket at least once a week. - Page 5 WINTERIZING CARE OF ELECTRIC MOTOR PROTECT FROM HEAT If the air temperature drops below 35º F. the water in the pump can freeze and cause damage. Freeze damage is not warrantable. 1. Shade the motor from the sun. 2. Any enclosure must be well ventilated to prevent overheating. 3.
-
Page 6: Pump Disassembly
PUMP DISASSEMBLY CAUTION: Be sure not to scratch or mar the polished seal faces. Seal will leak if faces are damaged. All moving parts are located in rear sub-assembly of this pump. 5. Remove the diffuser. Tools required: 6. Hold the impeller securely in place and remove the impeller lock •... - Page 7 Econo Flo VSA 165 Pump Replacement Parts FIGURE 3 Part No. Description 350V120 MTR, 56 Frame 1.65HP Variable Speed 672-1350 Neoprene Motor Support Strip 319-1500 Motor Base 311-1450 Volute Faceplate 711-1400 Gasket, Faceplate 811-1090 Ceramic Impeller Seal 310-7420 Champion 2 HP Full 2.5 HP UPR Impeller Assembly...
-
Page 8: Troubleshooting
RESTARTING INSTRUCTIONS & PRIMING THE PUMP CAUTION: DO NOT run the pump dry. If the pump is run dry, the mechanical seal will be damaged and the pump will start leaking. If this occurs, the damaged seal must be replaced. ALWAYS maintain proper water level in your pool.