MODEL # NEB-LSP-0007
ASSEMBLY AND INSTALLATION
WARNING: Never use a hammer to insert the light into the ground.
WARNING: The wire connector (B) contacts have sharp edges for piercing the
main low voltage cable. To avoid injury, do not touch the metal contacts.
CAUTION: The wire from low voltage power unit should be 12-18 AWG type
underground Low Energy Circuit Cable.
A
1. Preparation
• Before beginning assembly, compare parts with package
contents list to make sure all are present. If any part is
missing or damaged, do not attempt to assemble the
product.
• Estimated installation time: 10-15 minutes.
• No Tools Required for Assembly.
WELL LIGHT
Light Body (1)
A
B
Connector Clip (1)
B
IMPORTANT:
•
•
•
•
(Power Pack Sold Separately)
2. Installation
• Determine the location of your light. Dig a small hole
in the ground with a trowel.
• Press the light body into the hole until the light is secure, but
can still be adjusted.
• Dig a small trench from the light to the transformer wire.
• Secure the connector clip (B) to the transformer wire, as
shown above.
• Test the connection by turning on the lights. Make any
desired adjustments.
• Secure the light in the ground and fill in the trenches
with dirt.
USE AND CARE GUIDE
Do not submerge the fixture in water.
Do not install the fixture within
10 ft. of water.
The landscape wire can also be
hidden under surface.
Protect the wiring by routing it in
close proximity to the light fixture,
or next to a building structure.