Advertisement
SAFETY INSTRUCTIONS
• Regularly check nuts and bolts attaching the awning to your vehicle to make sure fastenings
are tight and in good condition.
• If using a commercial car wash, remove the aluminium hardshell and fixtures to avoid damage.
• Do not use awning or storage bag to hoist, lift or support yourself.
• It is important when mounting the awning to a vehicle, that all the mounting brackets supplied
are adequately spaced to support the weight of the awning.
• When mounting onto a vehicle with a rear canopy, the awning should be mounted to one or the
other, not span both vehicle roof and canopy.
• Products applied to a vehicle roof will alter vehicle handling. The manufacturer disclaims
all responsibility in relation to accidents due to improper use, incorrect maintenance, or
negligence in maintaining fastening hardware.
• This awning will support Tuatara accessory walls (KC077-067 - 2 X 2m Awning Front Wall and
Side Wall). Attaching different models, or inappropriate weight, could damage frame and will
not be covered by warranty.
• Do not attempt to put up in windy conditions.
• To avoid pooling of water on top of awning, always set up awning with sufficient angle to allow
water to run off.
TUATARA ALUMINIUM
HARDSHELL AWNING
2 x 2m Model No. KC077-062
2.5 x 2.5m Model No. KC077-063
Advertisement
Table of Contents
Related Manuals for Kiwi Camping KC077-062
Summary of Contents for Kiwi Camping KC077-062
- Page 1 TUATARA ALUMINIUM HARDSHELL AWNING 2 x 2m Model No. KC077-062 2.5 x 2.5m Model No. KC077-063 SAFETY INSTRUCTIONS • Regularly check nuts and bolts attaching the awning to your vehicle to make sure fastenings are tight and in good condition.
- Page 2 ATTACHMENT INSTRUCTIONS YOUR TUATARA AWNING INCLUDES: 1 x awning with travel cover 2 x L-brackets 4 x mounting plates 2 x guy ropes and pegs 4 x M8 x 16mm sets (bolt, nut and washer) 4 x M8 x 55mm sets (bolt, nut and washer) 4 x M8 x 35mm T-Bolt sets (bolt, nut and washer) You will also need: 1 x adjustable crescent spanner or a 10/13mm spanner...
- Page 3 To attach L-brackets to a crossbar Place the supplied L-bracket on top of your crossbars, with the vertical end facing away from the vehicle. Secure the L-bracket with M8 x 55mm bolt set provided. Tip - Ensure vertical faces of L-brackets are aligned before fully tightening.
- Page 4 PITCHING INSTRUCTIONS Release bottom elastic tabs on the aluminium travel cover. Remove the awning from the aluminium travel cover. Lift the awning fabric to access and release the side support poles from the aluminium travel cover. Move the poles out to the sides.
- Page 5 COLLAPSING INSTRUCTIONS Carefully remove pegs, remove excess soil and store them in their bag. Roll up guy ropes and store. Unfasten hook and loop tabs from the poles. Have someone support the front of the awning. Twist to unlock the side support poles.
- Page 6 CARE INSTRUCTIONS PLEASE READ ALL OF THE CARE INFORMATION AND INSTRUCTIONS INCLUDED WITH THIS AWNING BEFORE USING IT FOR THE FIRST TIME. Never store your awning away damp. Should mildew spots appear, brush them off before they become attached. Mildew damage of any kind is not covered by our warranty. DO NOT use excess force or other harsh tools to remove soilage from your awning.
- Page 8 WARRANTY INFORMATION The warranty period for this awning is found on the packaging and full details are on the Kiwi Camping website - www.kiwicamping.co.nz. The original purchaser of this product is offered a warranty if during this time period the product fails due to a fault in either materials or workmanship. Service under this warranty is available by returning the product, with your proof of purchase, to where it was purchased.
Need help?
Do you have a question about the KC077-062 and is the answer not in the manual?
Questions and answers