OPERATING INSTRUCTIONS
TO OPEN CHAIR
Open wheelchair by tilting one side and pushing
down on seat rail until fully opened.
WHEEL LOCKS
Engage both wheel locks before getting in or out of
chair, leaning forward in chair, or while in an eleva-
tor or wheelchair lift. Proper adjustment of wheel
lock is at least 1/8" when locked. Locks are engaged
by pushing handle completely forward. Adjustments
to locks are made by loosening or tightening nut on
the carriage bolt. Embed lock shoe at least 1/8" by
sliding clamp toward rear wheel while handle is
engaged in locked position. Tighten nut and bolt to
secure in position. Test for correct locking action
before actual use.
ADJUSTING LENGTH OF FOOT REST/LEG REST
When adjusting length of foot rests of leg rests, user
should be sitting in wheelchair with feet on the foot
plates. This product has push button height adjust-
able legs. Front rigging should not be so low that it
causes uncomfortable pressure thighs at front of
seat upholstery. Footrest should not be lower than 2
1/2" ron the ground to ensure clearance.
REMOVAL OF SWING-AWAY FOOT RESTS/LEG RESTS
Release lock by pushing on the front rigging lever.
Swing away foot rest/leg rest out and sideways. Lift
to remove.
TO CLOSE/FOLD CHAIR
First fold foot plates to vertical position. Grab seat
with both hands at front and back edge and left or
tilt chair to one side and lift up on seat rail.
MAINTENANCE
Do not use an abrasive cleaner will scratch the
finish. Wipe chrome parts with a clean, soft cloth
at least once a week. All metal parts can be
cleaned with auto wax or similar products. If
exposed to moisture, dry immediately.
TIRES
Solid rubber tires need minimal maintenance,
but should be cleaned occasionally with a damp
cloth. Repace if tires become severely worn or
cracking appears.
FRONT CASTERS
Casters should be checked periodically and
lubricated occasionally by an authorized dealer.
Rhythm Healthcare
Clearwater, FL 33762
contactus
rhythmhc.com
@
Website: www.rhythmhc.com
(877) 843-6464
V4: 9/1/23
Need help?
Do you have a question about the L3019 and is the answer not in the manual?
Questions and answers