Z.M. HEATERS ZM-135T Installation & Operating Manual

Z.M. HEATERS ZM-135T Installation & Operating Manual

18-35kw universal oil heater

Advertisement

Installation & Operating Manual
ZM-135T
18 – 35kW Universal Oil Heater
ZMH Ltd t/a Z M Heaters | www.zmheaters.co.uk | T. 00 44 (0) 333 600 44 60

Advertisement

Table of Contents
loading

Summary of Contents for Z.M. HEATERS ZM-135T

  • Page 1 Installation & Operating Manual ZM-135T 18 – 35kW Universal Oil Heater ZMH Ltd t/a Z M Heaters | www.zmheaters.co.uk | T. 00 44 (0) 333 600 44 60...
  • Page 2 OVERVIEW Dfdfdfdsfd Dfdfffdfdf Dfdfdf Deflector Overheat thermostat Wire ring Combustion chamber lid Combustion chamber Oil feed line Vaporising pan Activation thermostat Combustion chamber base Control panel & pump motor Overflow drain point Fuel tank Overflow catch pan & switch Cylinder Combustion fan ZMH Ltd t/a Z M Heaters | www.zmheaters.co.uk | T.
  • Page 3: Flue Installation

    FLUE INSTALLATION FITTING Ensure a suitable quality flue is used (SW430 grade). Maintaining the velocity of flue gases is important to ensure efficient combustion. Min flue Ø 150mm • CAUTION Ensure the draft stabiliser is fitted • Seal joints with suitable paste or •...
  • Page 4: General Instructions

    OVERVIEW Use on level non-combustible • surfaces only The ZM-135T universal oil heater is Do not use near flammable liquids, • designed for warm air heating of industrial gases, solids, dust or compressed spaces like workshops, warehouses etc.
  • Page 5: Installation

    The Health & Safety at Work Act 1974 INSTALLATION places responsibility for safe condition of 1. Place the heater on a strong, flat, level, electrical appliances upon owners. Power surface of concrete or similar cables and plugs should always be regularly inspected for safety.
  • Page 6: Operation

    “START” button should be pressed immediately after lighting the heater and the “STOP” button should be pressed to stop the fuel supply and allow the heater to cool. SPECIFICATIONS Type ZM-135T Max output 35 kW Min output 18 kW Airflow 1,000m3 / hr Max oil use 3.5 ltr / hr...
  • Page 7 To clear the overheating signal and return STARTING to normal operation, wait until the furnace 1. Drain any water in the fuel tank (when is cooled down and the fan is switched off necessary) and fill with oil then press the push-button overheat thermostat to reset.
  • Page 8 WIRING TO CONTROL PANEL ZMH Ltd t/a Z M Heaters | www.zmheaters.co.uk | T. 00 44 (0) 333 600 44 60...

Table of Contents