Summary of Contents for Logstream VR1
- Page 1 3.0 manual version: 1.2 September 2023 © 2023 Logstream Sp z o.o...
-
Page 2: Main Features
32-bit microprocessor for very accurate indications. The data is displayed on a very high brightness LCD screen. VR1 is equipped with a rotary knob with a pushbutton for controlling the device. Main features. dimensions 65x63x80 mm weight 210g ... - Page 3 Turning off the device 1) By pressing and holding the button on the rotary knob for 4 seconds 2) By selecting "Power off" in the main menu © 2023 Logstream Sp z o.o...
-
Page 4: Graphical User Interface
Vario scale range ( 2.5, 5.0, 10.0 m/s ) is user adjustable. Turning the knob in this mode increases (right) or decreases (left) the volume. Pressing the knob in this mode takes you to the setting mode. © 2023 Logstream Sp z o.o... - Page 5 Averager - average vario. Set how many seconds to take the average Range – variometer scale ( 2.5, 5.0, 10.0 m/s ) Nmea out – format of data sent outside via the UART port © 2023 Logstream Sp z o.o...
- Page 6 Initial volume - default volume when the device is turned on. During the flight, you can easily change the volume by turning the knob on the main screen Vario tone – sound parameters Exit - exit to the main menu Vario tone screen © 2023 Logstream Sp z o.o...
- Page 7 Sleep mode - when this option is turned on, the device goes into sleep mode immediately after connecting to the power supply (from which you can exit by pressing the knob) © 2023 Logstream Sp z o.o...
- Page 8 Vertical speed – vario units Altitude – altitude – atmospheric pressure Pressure Screen Info This screen shows the device data. Eg. hardware and software version. Turning the knob moves to the next sub-screens. Menu Others © 2023 Logstream Sp z o.o...
- Page 9 Default 700m Lower altitude - enter the altitude beyond which the variometer will generate a voice reminder about the landing gear. Default 200m Test warning - pressing generates a warning © 2023 Logstream Sp z o.o...
- Page 10 Service code screen The screen is used to enter the service codes received from the manufacturer in order to perform service activities (e.g. automatic device diagnostics). Do not enter any values here alone. © 2023 Logstream Sp z o.o...
- Page 11 Pin 4.5 - not used Pin 3 - ground (GND) Installation of the device in the glider: The device should be mounted in a standard mounting hole ( 57mm ) using the attached screws. © 2023 Logstream Sp z o.o...
- Page 12 In the Audio options, set the Speaker sound output to External. Firmware update: When a new version of the device firmware is available, the manufacturer will send the user a binary file with update instructions. Contact: mail: office@logstream.eu www.logstream.eu © 2023 Logstream Sp z o.o...
- Page 13 You may also be directed to an authorized reseller or a person authorized by Logstream to repair the product. If it is decided that this product should be returned directly to Logstream, this product should be properly packed, preferably in the original carton, for shipping.
- Page 14 2. this product is not purchased from Logstream or an authorized Logstream reseller. If you are unsure whether a reseller is an authorized Logstream reseller, please visit our web site at www.logstream.eu or contact a Logstream office. Logstream thanks you for purchasing a Logstream product.