Advertisement
Projector Alignment
To adjust yaw (swivel) for wood stud and concrete ceiling: Loosen wood screws (F) if flush mounted to wood
8
joists (page 5) or concrete ceilings (page 6), until projector mount can be rotated. Rotate mount to desired
position and retighten screws.
To adjust yaw (swivel) for extension column applications: Loosen screw on projector mount assembly (A)
indicated below until projector mount can be rotated. Rotate mount to desired position and retighten screw.
To adjust pitch (forward and backward tilt): Turn knob on back of mount as shown below. Pull knob out and
turn by hand for easy adjustment or insert #2 phillips screwdriver in end of knob and turn.
To adjust roll (side to side tilt): Turn knob on side of mount as shown below. Pull knob out and turn by hand for
easy adjustment or insert #2 phillips screwdriver in end of knob and turn.
ARROW INDICATES
FRONT OF MOUNT
SCREW FOR YAW (SWIVEL) STOP
(REFER TO STEP 1, INSTALLATION
TO EXTENSION COLUMNS, FIG. 1.2)
To prevent tampering with the pitch and roll adjustments: Tighten the two tamper resistant security screws
8-1
on the projector mount assembly using 4mm security allen wrench (B) to lock the pitch and roll adjustments as
shown below. Note: Tighten screws firmly, but do not overtighten. Overtightening can damage the mount.
• Do not adjust pitch or roll while tamper resistant security screws are fully engaged.
• Loosen the two tamper resistant security screws one complete turn before adjusting the projector mount assembly
or damage may occur.
TO LOCK PITCH,
TIGHTEN TAMPER
RESISTANT
SECURITY SCREW
Visit the Peerless Web Site at www.peerlessmounts.com
A
CAUTION
SIDE VIEW
9 of 9
All other brand and product names are trademarks or registered trademarks of their respective owners.
KNOB FOR PITCH
ADJUSTMENT
BACK OF MOUNT
KNOB FOR ROLL
ADJUSTMENT
ISSUED: 2010-01-10
SHEET #: 056-9034-9
For customer care call 1-800-865-2112
© 2023, Peerless Industries, Inc. All rights reserved.
(2023-04-20)
Advertisement
